This sounds like a problem I ran into on another processor/platform.
What are you using for a ramdisk? Is it busybox? There was a bug in
0.51 busybox that would not let it accept input from a console on a
serial port. It had to do with the init for the serial port. You can
check the patch file below to see the problem that was in busybox...
--- init.c.orig Sat Apr 21 17:46:57 2001
+++ init.c Sat Apr 21 17:46:31 2001
@@ -276,7 +276,7 @@
/* Make it be sane */
tty.c_cflag &= CBAUD|CBAUDEX|CSIZE|CSTOPB|PARENB|PARODD;
- tty.c_cflag |= HUPCL|CLOCAL;
+ tty.c_cflag |= CREAD|HUPCL|CLOCAL;
/* input modes */
tty.c_iflag = ICRNL | IXON | IXOFF;
On 22 Jul 2001 23:51:25 -0700, Barry Wu wrote:
>
> Hi, all,
>
> I am porting linux 2.4.3 to our mipsel evaluation
> board. Now I meet a problem. Because I use edown
> to download the linux kernel to evaluation board.
> I update the serial baud rate to 115200.
> I use serial 0 as our console, and I can use
> printk to print debug messages on serial port.
> But after kernel call /sbin/init, I can not
> see "INIT ... ..." messages on serial port.
> I suppose perhaps I make some mistakes. But when
> I use 2.2.12 kernel, it ok.
> If someone knows, please help me. Thanks!
>
> Barry
>
> __________________________________________________
> Do You Yahoo!?
> Make international calls for as low as $.04/minute with Yahoo! Messenger
> http://phonecard.yahoo.com/
--
/*************************
Marc Karasek
Sr. Firmware Engineer
iVivity Inc.
marc_karasek@ivivity.com
(770) 986-8925
(770) 986-8926 Fax
*************************/
