On 09/24/2011 09:52 PM, Ray Morris wrote: > .. also RTFM with a link to the right manual would be >> kindly appreciated (if you know that an answer for my question exist >> in the manual) ;) > > man lvm | grep -5 partial Ok, thanks very much for the answer, but I already tried the "partial" option: On 08/31/2011 11:26 AM, benry wrote: > > I tried this command: "vgchange -P -a y raid", but the device > > /dev/raid/data does not exist anyway. Maybe I do not understand very well the part where it says "/dev/ioerror will be substituted, and you could use dmsetup (8) to set this up to return I/O errors when accessed, or create it as a large block device of nulls." Is this optional or I have to do something with dmsetup to let the command "vgchange -P -a y raid" work correctly? Maybe I am missing what is the right purpose of this /dev/ioerror device. > You probably do not need: > man pvcreate | grep -2 uuid Ok, so, this is needed to let the new pv (sda RAID) to be initialized with the same uuid of the old one... right? If I use it on the new drive, LVM will believe to have the old pv and will make the volume available, apart from the fact that it will not find data in it. This makes sense to me ;) >> LVM was configured to use sda and sdb in linear mode... not >> stripping... so theoretically data in sdb should be readable, right? > > The data on sdb is there, but it's probably not a correct filesystem, > so reading it may be difficult. Ok, this makes sense too... what I'll try to do (since the lv was containing an XFS filesystem) is to use the xfs_repair command, that as far as I understood should look for pieces of an XFS filesystem and try to repair it. In conclusion, what I could try to do is: 1) create a new pv in the new RAID with the same uuid of the old one (pvcreate) 2) activate the lv (vgchange) 3) try xfs_repair on the lv crossing my fingers Right? Thanks very much for the help... I read a lot of documentation, but since I do not have a lot of experience with LVM and I am really afraid of damaging also the remaining data, I kindly appreciate to have some of your comments. Enrico _______________________________________________ linux-lvm mailing list linux-lvm@redhat.com https://www.redhat.com/mailman/listinfo/linux-lvm read the LVM HOW-TO at http://tldp.org/HOWTO/LVM-HOWTO/
