Hi Folks,
I've been busily rebuilding from a crash, and running into a sticky
problem - my root volume is an LVM2 LV, built on top of a LVM2 PV, which
in turn is built on top of a raided array (md - RAID1 configuration).
The machine has 4 SATA drives (2 channels, master/slave in each).
It was a funny crash - it first looked like a hardware failure
corrupting two drives; turns out it was a single drive that failed in a
way that it kept responding, but taking a VERY long time to do so (10s
of seconds) - the system kept running, but everything slowed to a
crawl. Not sure why the failure wasn't detected but that's a story for
another day.
With the drive removed, everything came back up, but all 4 RAID one
devices had become degraded and did not automatically rebuild themselves
- they were all effectively running as a single drive.
After inserting a spare drive and formatting it, I started doing hot
adds (mdadm --add) and 3 of 4 arrays are now working properly
Which brings us to the fourth array... which supports my root volume,
configuration is something like this:
before crash:
/
Logical Volume
Physical Volume
RAID1 array - 2 active, one spare
after crash and partial recovery:
/
Logical Volume
Physical Volume
RAID1 array - showing inactive, running on spare drive alone
On the other volumes, when I did a hot add (mdadm --add ...) the added
drives started resyncing and now all is fine. On this array, the new
drives shows as "spare rebuilding" but it doesn't really seem to be
doing anything.
So... my question becomes: if I can't figure out how to get md to
rebuild the array "underneath" LVM, how do I unwind all of this, and
rebuild things - without becoming unrunable without a root volume?
Thanks for any suggestions anyone can offer.
Miles Fidelman
_______________________________________________
linux-lvm mailing list
linux-lvm@redhat.com
https://www.redhat.com/mailman/listinfo/linux-lvm
read the LVM HOW-TO at http://tldp.org/HOWTO/LVM-HOWTO/
