On Fri, Jun 30, 2006 at 12:53:36PM +0200, Dieter St?ken wrote: > Cristian Livadaru wrote: > > I have created some new lv's for some tests. > > What I did was based on this howto: > > > > http://www.tldp.org/HOWTO/LVM-HOWTO/recipethreescsi.html > > > > pvcreate /dev/hdk > > pvcreate /dev/hdi > > > > vgcreate vhostvg /dev/hdk /dev/hdi > > > > lvcreate -L1G -nvm01lv vhostvg > > ok and here I thinkg I made a big mistake! > > since I had no partitions on my disks and I assumed that I needed one so > > that it matches the LVM that was created by debian automaticaly I > > created on both disks a partition and changed the type to 8e Linux LVM. > > I actualy worked with the lv's and everything is ok ( except my speed > > problem but this is a other topic ) > > now after a rebbot, I only see the lv created by debian, not the one > > that I kind of screwed up with my partitioning. > > > > Is there a simple way to recover it? It's not that important that I > > would wast to much time with it, it was just for testing anyway and I > > could recreate them. > > You created the partitions, but as long as you did not write any data > to the created partition, nothing bad happened so far. Just delete > the partition again. The partition table resides in the first sector > of the disk, which is fortunately unused by LVM. I already did a lot on the partition. thanks anyway but the data on that lvm wasn't that important. I just reinstalled everything. Cris _______________________________________________ linux-lvm mailing list linux-lvm@redhat.com https://www.redhat.com/mailman/listinfo/linux-lvm read the LVM HOW-TO at http://tldp.org/HOWTO/LVM-HOWTO/
