|
I just installed FC3 on a brand new 80gb hard drive. Up until this point I have been using Redhat 7.3, so this whole thing with LVM is pretty new to me.
I had the drive partitioned into three parts (on top of the boot and swap partition):
/ 20gb
/dstar 10gb /home 45gb However, when I use df, I get this:
dracon:/home/infoteq# df
Filesystem 1K-blocks Used Available Use% Mounted on
/dev/mapper/VolGroup00-LogVol00 20158332 5611396 13522936 30% / When I use lvdsiplay, I get this:
dracon:/home/infoteq# lvdisplay
--- Logical volume --- LV Name /dev/VolGroup00/LogVol00 VG Name VolGroup00 LV UUID Ud4qo5-Ysba-HETb-mm0u-ntvi-oEI0-kzreZ7 LV Write Access read/write LV Status available # open 1 LV Size 19.53 GB Current LE 625 Segments 1 Allocation inherit Read ahead sectors 0 Block device 253:0 --- Logical volume --- LV Name /dev/VolGroup00/LogVol02 VG Name VolGroup00 LV UUID d2CYD9-8fOX-fVd5-VFdF-7kuL-7P7U-Ed9ERM LV Write Access read/write LV Status available # open 0 LV Size 9.78 GB Current LE 313 Segments 1 Allocation inherit Read ahead sectors 0 Block device 253:1 --- Logical volume --- LV Name /dev/VolGroup00/LogVol03 VG Name VolGroup00 LV UUID 7rHvJC-5SNh-HO7I-acKM-3n0B-teFy-XlVZMa LV Write Access read/write LV Status available # open 0 LV Size 44.06 GB Current LE 1410 Segments 1 Allocation inherit Read ahead sectors 0 Block device 253:2 --- Logical volume --- LV Name /dev/VolGroup00/LogVol01 VG Name VolGroup00 LV UUID AZ0FwK-KL1j-CAPS-emtT-3Uzt-Xlhi-I3t127 LV Write Access read/write LV Status available # open 1 LV Size 1.00 GB Current LE 32 Segments 1 Allocation inherit Read ahead sectors 0 Block device 253:3 My fstab shows this:
/dev/VolGroup00/LogVol00 / ext3 defaults 1 1
LABEL=/boot /boot ext3 defaults 1 2 none /dev/pts devpts gid=5,mode=620 0 0 none /dev/shm tmpfs defaults 0 0 /dev/VolGroup00/LogVol02 /dstar ext3 defaults 1 2 /dev/VolGroup00/LogVol03 /home ext3 defaults 1 2 none /proc proc defaults 0 0 none /sys sysfs defaults 0 0 /dev/VolGroup00/LogVol01 swap swap defaults 0 0 So the drives are there, and I have put data on them, but for some reason, it won't display it on df. I've looked all over for some sort of clue as to why this happened, but have come up empty handed.
Is there some way to fix df so that it will display the information correctly? If not, is there some way I can avoid causing this problem in the future?
Thanks for your time,
-Jay
|
_______________________________________________ linux-lvm mailing list linux-lvm@redhat.com https://www.redhat.com/mailman/listinfo/linux-lvm read the LVM HOW-TO at http://tldp.org/HOWTO/LVM-HOWTO/
