Hi! Maybe you have too much device inodes to check but otherwise uninteresting? In this case it is not proportional to the amount of your storage. The solution to this is either filter what you scan, or if you can, you can try to either rm unnecessary files from /dev, or tell your *scan programs to look at a different directory, and polupate it only with the needed devices. At the worst case you can do it by editing the path in the source and recompile. A levelezőm azt hiszi, hogy Dan Bar Dov a következőeket írta: > When I start up our system, I have a startup script that runs pvscan, vgscan > and lvscan, and parses their output. > > This takes too long - with a small SAN - 1x6 disks FC jbod + 2 FC RAID > controllers, it takes roughly 45 seconds with pvscan and vgscan about 23 > seconds each. > > Its pretty obvious that with more storage it will take longer. > > Any ideas how can I speed it up? > (can I run vgscan/pvscan in parallel ?, can I get all the data I need from a > single scan ?) > > Thanks > Dan > > _______________________________________________ > linux-lvm mailing list > linux-lvm@redhat.com > https://www.redhat.com/mailman/listinfo/linux-lvm > read the LVM HOW-TO at http://tldp.org/HOWTO/LVM-HOWTO/ > -- GNU GPL: csak tiszta forrásból _______________________________________________ linux-lvm mailing list linux-lvm@redhat.com https://www.redhat.com/mailman/listinfo/linux-lvm read the LVM HOW-TO at http://tldp.org/HOWTO/LVM-HOWTO/
