Things are getting better. I found 2 of the 3 lv's that were missing. I am trying to find the last one. All of the vg's and lv's were created under lvm 1.0.2. I am now using 1.1-rc2. If I type either: vgdisplay -v sdd_vol4 or vgdisplay -v sdd2_vol12 I get the same results, both for sdd2_vol12. That vg does not yet have a lv. I get the same results from different nodes (storage is fiber attached). Is there a maximum number of vg's that are supported? Is there a maximum length that a vg name can be? When I first configured the new disks I had some problems where trying to run vgdisplay on the volumes named 'sdd_vol1?' I would only get the results for sdd_vol1. Is there an 8 character max built in? Craig On Thu, May 02, 2002 at 01:34:40PM -0500, John Moser wrote: > > > [root@x06 /root]# mount -t ext3 /dev/sdd_vol2/ /export/sdd_vol2 > > mount: /dev/sdd_vol2/ is not a block device > > > > IO nodes have gone down in the past due to > > power interruptions, but I have never had > > this catastrophic of a problem. I have 16 volume > > groups, and 3 or 4 appear to be affected. > > Have you tried a simple: > > vgchange -a y > > ? Similar situation happened to me before, and I just needed to activate > the volume group. > > -John > > > _______________________________________________ > linux-lvm mailing list > linux-lvm@sistina.com > http://lists.sistina.com/mailman/listinfo/linux-lvm > read the LVM HOW-TO at http://www.sistina.com/lvm/Pages/howto.html -- Craig Tierney (ctierney@hpti.com) _______________________________________________ linux-lvm mailing list linux-lvm@sistina.com http://lists.sistina.com/mailman/listinfo/linux-lvm read the LVM HOW-TO at http://www.sistina.com/lvm/Pages/howto.html
