Hi Jean,
it works. I didn't thought about trying out "sensors" without the chip
being found by sensors-detect. Its properly detected with the updated
sensors-detect as well.
Here is the output of sensors:
Before:
martin@computername ~/it87 $ sensors
k10temp-pci-00c3
Adapter: PCI adapter
temp1: +4.5°C (high = +70.0°C)
(crit = +70.0°C, hyst = +69.0°C)
Now:
martin@computername ~/it87 $ sensors
k10temp-pci-00c3
Adapter: PCI adapter
temp1: +5.0°C (high = +70.0°C)
(crit = +70.0°C, hyst = +69.0°C)
it8603-isa-0290
Adapter: ISA adapter
in0: +0.85 V (min = +1.21 V, max = +0.78 V) ALARM
in1: +1.63 V (min = +0.86 V, max = +1.52 V) ALARM
in2: +2.04 V (min = +1.97 V, max = +0.38 V) ALARM
in3: +2.02 V (min = +0.47 V, max = +0.02 V) ALARM
in4: +1.24 V (min = +0.43 V, max = +0.14 V) ALARM
3VSB: +3.34 V (min = +1.87 V, max = +1.54 V) ALARM
Vbat: +3.24 V
+3.3V: +3.38 V
fan1: 1066 RPM (min = 200 RPM)
fan2: 0 RPM (min = 602 RPM) ALARM
temp1: +34.0°C (low = +116.0°C, high = +32.0°C) ALARM sensor =
thermistor
temp2: +33.0°C (low = +99.0°C, high = +0.0°C) ALARM sensor =
thermistor
temp3: -128.0°C (low = -30.0°C, high = -80.0°C) sensor = thermistor
intrusion0: OK
And sensors-detect:
...
Found `ITE IT8623E Super IO Sensors' Success!
(address 0x290, driver `it87')
...
Driver `it87':
* ISA bus, address 0x290
Chip `ITE IT8623E Super IO Sensors' (confidence: 9)
Thank you all for your help.
Best Regards
Martin
On 25.03.2014 12:36, Jean Delvare wrote:
Hi Martin,
On Tue, 25 Mar 2014 11:12:46 +0100, Martin Herrholz wrote:
i did install the module like mentioned in your linked Instructions and
redone the sensors-detect.
I still get the same result:
Trying family `ITE'... Yes
Found unknown chip with ID 0x8623
(logical device 4 has address 0x290, could be sensors)
This is expected, sensors-detect has its own detection code which is
independent from the installed drivers. You can try the latest version
at:
http://dl.lm-sensors.org/lm-sensors/files/sensors-detect
which should detect your chip properly.
I had no it87 module installed prior to it, so i had nothing to remove.
The module compiles/loads without errors.
Great. But does it work? What does "sensors" say?
_______________________________________________
lm-sensors mailing list
lm-sensors@xxxxxxxxxxxxxx
http://lists.lm-sensors.org/mailman/listinfo/lm-sensors
