On Thu, Nov 14, 2013 at 7:00 PM, Guenter Roeck <linux@xxxxxxxxxxxx> wrote: > What are those pins used for ? I would like to drive them dynamically like the rest of the features exposed to the sysfs in a similar way. For instance, one may need to output a logic-low level on the pin 0 to get an operation working. One use case could be (and is) enabling or disabling the fans dynamically based on the temperature, etc condition. Imagine that if you have a 12 V fan with 5 V board power supply, and such a pin would be useful to establish the bridge between them with diodes. This is just one use case of those, you could also use it for non-generic gpio functionality, like alarm, "full-on", internal clock, external clock, etc. I believe it is always a bit tricky with MFD. I personally prefer to put it into the chip driver because this is not clearly a generic gpio interface here, and I need to drive it dynamically. _______________________________________________ lm-sensors mailing list lm-sensors@xxxxxxxxxxxxxx http://lists.lm-sensors.org/mailman/listinfo/lm-sensors
