On Mon, Nov 11, 2013 at 10:31:40AM -0800, p. stephen w wrote: > woot-woot, that was it. Running Make install did the trick. Like I said, > I'm a Linux noob. > > Where can I send you $50? > That was free of charge ... Guenter > > On Mon, Nov 11, 2013 at 10:29 AM, Guenter Roeck <linux@xxxxxxxxxxxx> wrote: > > > On Mon, Nov 11, 2013 at 10:17:00AM -0800, p. stephen w wrote: > > > I just followed the link from the lm-sensors devices page to the GitHub > > > page (is that yours?), and re-cloned it. This time the output was a > > little > > > different, and I have a few .ko files in my personal directory. They are > > > not in the hwmon dir. I thought I might try moving them there and > > > re-running sensors-detect. > > > > > > Githum repo: > > > https://github.com/groeck/nct6775.git > > > > > > Make: > > > Mint nct6775 # make all > > > CC [M] /home/stephen/nct6775/nct6775.o > > > > > > Building modules, stage 2. > > > MODPOST 1 modules > > > CC /home/stephen/nct6775/nct6775.mod.o > > > LD [M] /home/stephen/nct6775/nct6775.ko > > > > > > > > I asked earlier if you did run "make install". Looks like you didn't. > > > > > > > Contents of home dir after make all: > > > Mint nct6775 # ls > > > compat.h Makefile nct6775.c nct6775.mod.o README.ASRock > > > LICENSE modules.order nct6775.ko nct6775.o > > > lm75.h Module.symvers nct6775.mod.c README > > > > > > > > > Sensors -v > > > Mint nct6775 # sensors -v > > > sensors version 3.3.4 with libsensors version 3.3.4 > > > > > > > > > > > > I run everything as root. > > > Should I copy any of the .ko, .o, and .c files from your driver into any > > > other folders? > > > > > Run "make install" followed by "modprobe nct6775". > > > > > I'm using the sensors-detect that came with the manual installation of > > > lm-sensors, latest version. I don't have a prog/detect, either folder or > > > command. > > > > The prog/detect directory is in the lm-sensors source, so if you > > cloned lm-sensors from github or svn you should have it. > > > > Thanks, > > Guenter > > > > > Just run sensors_detect from prog/detect/. I am not sure if you > > actually > > > installed it. If not, you just keep running the installed version. > > > > > > -- > > > > > > > > > _____________________________ > > > Stephen Wille | pstephenwille.com > > > *new address p.stephenwille@xxxxxxxxx <p.stephenwille@xxxxxxxxx>* > > > _______________________________________________ > > > lm-sensors mailing list > > > lm-sensors@xxxxxxxxxxxxxx > > > http://lists.lm-sensors.org/mailman/listinfo/lm-sensors > > > > > > > > > -- > > > _____________________________ > Stephen Wille | pstephenwille.com > *new address p.stephenwille@xxxxxxxxx <p.stephenwille@xxxxxxxxx>* _______________________________________________ lm-sensors mailing list lm-sensors@xxxxxxxxxxxxxx http://lists.lm-sensors.org/mailman/listinfo/lm-sensors
