Hi Johannes,
On Thu, Jul 26, 2012 at 03:53:12PM +0200, Johannes Winkelmann wrote:
> Hi Guenter,
>
> Thanks a lot for the feedback; I've incorporated most of it in
> preparation for a v2 of the patch; I have some comments on the points
> I'm not certain about:
>
[ ... ]
> >> +
> >> +The device communicates with the I2C protocol. All sensors are set to the same
> >> +I2C address 0x70, so an entry with I2C_BOARD_INFO("shtc1", 0x70) can be used
> >> +in the board setup code.
> >> +
> > Please also provide a reference to the other means to instantiate the driver.
>
> I've checked a couple of documentation files and haven't found what
> else I should add, in fact the other sensor documents I checked didn't
> cover this, except for the one from the sht21 after which I modelled
> the document. Could you give me a pointer where to look?
>
Just add a reference to Documentation/i2c/instantiating-devices.
Thanks,
Guenter
_______________________________________________
lm-sensors mailing list
lm-sensors@xxxxxxxxxxxxxx
http://lists.lm-sensors.org/mailman/listinfo/lm-sensors
