On 8/12/2011 3:07 AM, Roger Quadros wrote:
On 08/11/2011 01:55 PM, Felipe Balbi wrote:
Hi,
On Thu, Aug 11, 2011 at 09:54:09PM +0300, Felipe Balbi wrote:
you need some other way to handle this. Why do you need to manually set
the rate rather than having hwmod handle this for you ?
your argument that "it's a one time setting" is not enough to have this
in the driver. Drivers should not care about clocks anymore, this should
have been done on another layer.
Hwmod will have no idea on the rate required.
does the rate need to change ? Also, I have not mentioned hwmod anytime
i did mention hwmod, nevermind that part. Still I'm not sure where is
the right place to handle this.
Aren't the omap_device_pm_latency callbacks the right place to do it?
e.g. in the following snippet from mach-omap2/temp_sensor_device.c
+static struct omap_device_pm_latency omap_temp_sensor_latency[] = {
+ {
+ .deactivate_func = omap_device_idle_hwmods,
+ .activate_func = omap_device_enable_hwmods,
+ .flags = OMAP_DEVICE_LATENCY_AUTO_ADJUST,
+ }
+};
instead of directly pointing activate_func to omap_device_enable_hwmods,
it could point to a function that sets the required clock rate and then
enables the hwmod.
FWIK, its a one time requirement to set the clock rate to the
right rate the device can operate in based on what a platform
supports. What you are suggesting would add the overhead of doing
this every time the device is runtime enabled/idled.
regards,
-roger
_______________________________________________
lm-sensors mailing list
lm-sensors@xxxxxxxxxxxxxx
http://lists.lm-sensors.org/mailman/listinfo/lm-sensors
