Hi!
The Bios says 1.8V.
In the afternoon I noticed that the fans weren't shown and that I had
to put the acpi_enforce_resoures=lax option in grub.
The modules that i needed were i2c-i801, smsc47m1, smsc47m192.
The final configuration is:
# Configuration for Intel DG945GCLF
chip "smsc47m1-*"
label fan1 "fan case"
# The minimum speed for fans with this chip is 1300. So, if you have a
disconnected fan
# your best option is to ignore it
# ignore fan1
# set fan1_min 1300
label fan2 "fan cpu"
chip "smsc47m192-*"
label in0 "+2.5V"
set in0_min 2.5 * 0.95
set in0_max 2.5 * 1.05
label in1 "Vcore"
set in1_min 0.9
set in1_max 1.162
label in2 "+3.3V"
set in2_min 3.3 * 0.90
set in2_max 3.3 * 1.10
label in3 "+5V"
set in3_min 5.0 * 0.90
set in3_max 5.0 * 1.10
label in4 "+12V"
set in4_min 12.0 * 0.90
set in4_max 12.0 * 1.10
label in5 "VCC"
set in5_min 3.3 * 0.90
set in5_max 3.3 * 1.10
label in6 "+1.5V"
set in6_min 1.5 * 0.90
set in6_max 1.5 * 1.10
label in7 "+1.8V"
set in7_min 1.8 * 0.90
set in7_max 1.8 * 1.10
label temp1 "Chipset Temp"
set temp1_min 0
set temp1_max 90
label temp2 "CPU Temp"
set temp2_min 0
set temp2_max 85
label temp3 "System Temp"
set temp3_min 0
set temp3_max 75
Best regards,
Marcelo Coelho
2011/5/29 Jean Delvare <khali@xxxxxxxxxxxx>:
> Hi Marcelo,
>
> On Sat, 28 May 2011 11:00:28 +0100, Marcelo Coelho wrote:
>> Hi,
>>
>> I don't have a wiki account, so anyone that has one can put this in
>>
>> intel/D945GCLF ?
>
> Done:
> http://www.lm-sensors.org/wiki/Configurations/Intel/D945GCLF
>
> Thanks for your contribution.
>
>> label in7 "+1.8V"
>> set in7_min 1.8 * 0.90
>> set in7_max 1.8 * 1.10
>
> Presumably this is the DDR2 memory module voltage? What does the BIOS
> say?
>
> --
> Jean Delvare
>
_______________________________________________
lm-sensors mailing list
lm-sensors@xxxxxxxxxxxxxx
http://lists.lm-sensors.org/mailman/listinfo/lm-sensors
