The PCF8591 can't be detected, don't even try. There are plenty of
other means to instantiate i2c devices these days.
Signed-off-by: Jean Delvare <khali@xxxxxxxxxxxx>
Cc: Aurelien Jarno <aurelien@xxxxxxxxxxx>
---
Documentation/hwmon/pcf8591 | 18 ++++++++----------
drivers/hwmon/pcf8591.c | 26 --------------------------
2 files changed, 8 insertions(+), 36 deletions(-)
--- linux-2.6.36-rc6.orig/Documentation/hwmon/pcf8591 2010-08-02 00:11:14.000000000 +0200
+++ linux-2.6.36-rc6/Documentation/hwmon/pcf8591 2010-10-05 13:14:59.000000000 +0200
@@ -4,7 +4,7 @@ Kernel driver pcf8591
Supported chips:
* Philips/NXP PCF8591
Prefix: 'pcf8591'
- Addresses scanned: I2C 0x48 - 0x4f
+ Addresses scanned: none
Datasheet: Publicly available at the NXP website
http://www.nxp.com/pip/PCF8591_6.html
@@ -58,18 +58,16 @@ Module parameters
Accessing PCF8591 via /sys interface
-------------------------------------
-! Be careful !
-The PCF8591 is plainly impossible to detect! Stupid chip.
-So every chip with address in the interval [0x48..0x4f] is
-detected as PCF8591. If you have other chips in this address
-range, the workaround is to load this module after the one
-for your others chips.
+The PCF8591 is plainly impossible to detect! Thus the driver won't even
+try. You have to explicitly instantiate the device at the relevant
+address (in the interval [0x48..0x4f]) either through platform data, or
+using the sysfs interface. See Documentation/i2c/instantiating-devices
+for details.
-On detection (i.e. insmod, modprobe et al.), directories are being
-created for each detected PCF8591:
+Directories are being created for each instantiated PCF8591:
/sys/bus/i2c/devices/<0>-<1>/
-where <0> is the bus the chip was detected on (e. g. i2c-0)
+where <0> is the bus the chip is connected to (e. g. i2c-0)
and <1> the chip address ([48..4f])
Inside these directories, there are such files:
--- linux-2.6.36-rc6.orig/drivers/hwmon/pcf8591.c 2010-10-05 13:03:39.000000000 +0200
+++ linux-2.6.36-rc6/drivers/hwmon/pcf8591.c 2010-10-05 13:16:43.000000000 +0200
@@ -25,10 +25,6 @@
#include <linux/mutex.h>
#include <linux/hwmon.h>
-/* Addresses to scan */
-static const unsigned short normal_i2c[] = { 0x48, 0x49, 0x4a, 0x4b, 0x4c,
- 0x4d, 0x4e, 0x4f, I2C_CLIENT_END };
-
/* Insmod parameters */
static int input_mode;
@@ -169,24 +165,6 @@ static const struct attribute_group pcf8
* Real code
*/
-/* Return 0 if detection is successful, -ENODEV otherwise */
-static int pcf8591_detect(struct i2c_client *client,
- struct i2c_board_info *info)
-{
- struct i2c_adapter *adapter = client->adapter;
-
- if (!i2c_check_functionality(adapter, I2C_FUNC_SMBUS_BYTE
- | I2C_FUNC_SMBUS_WRITE_BYTE_DATA))
- return -ENODEV;
-
- /* Now, we would do the remaining detection. But the PCF8591 is plainly
- impossible to detect! Stupid chip. */
-
- strlcpy(info->type, "pcf8591", I2C_NAME_SIZE);
-
- return 0;
-}
-
static int pcf8591_probe(struct i2c_client *client,
const struct i2c_device_id *id)
{
@@ -306,10 +284,6 @@ static struct i2c_driver pcf8591_driver
.probe = pcf8591_probe,
.remove = pcf8591_remove,
.id_table = pcf8591_id,
-
- .class = I2C_CLASS_HWMON, /* Nearest choice */
- .detect = pcf8591_detect,
- .address_list = normal_i2c,
};
static int __init pcf8591_init(void)
--
Jean Delvare
_______________________________________________
lm-sensors mailing list
lm-sensors@xxxxxxxxxxxxxx
http://lists.lm-sensors.org/mailman/listinfo/lm-sensors
