On Sun, Jun 27, 2010 at 06:20:59AM -0400, Mark Brown wrote: > On Thu, Jun 24, 2010 at 03:00:58PM -0700, Guenter Roeck wrote: > > This driver adds support for the monitoring features of the Summit > > Microelectronics SMM665 Six-Channel Active DC Output Controller/Monitor. > > A bit late to the game here but this looks like the chip has some > regulator control functionality as well as monitoring functionality (and > the product page on the Summit web site suggests so also). This means > that when fully supported in software the driver would cross multiple > subsystems so it might make sense to start off with a MFD rather than > direct I2C control? > > If the non-monitoring functionality can't be controlled from software > this isn't an issue. I thought about that when I started working on the driver, but concluded that it does not really make sense. The chip is commonly used to control all supply voltages on a board. Changing those voltages is not a good idea. For that reason, the chip can be set into read-only mode, where changing the voltages is no longer possible after initial programming. While it is theoretically possible that someone might use the device to control not only fixed but also dynamic voltages, I think that is highly unlikely, given the risk involved in blowing up the board. Thus, moving the driver to mfd would effectively serve no real purpose other than to cause confusion and add unnecessary complexity. Guenter _______________________________________________ lm-sensors mailing list lm-sensors@xxxxxxxxxxxxxx http://lists.lm-sensors.org/mailman/listinfo/lm-sensors
