> On Wed, 13 Jan 2010 17:31:42 +0100, Manuel Lamotte-Schubert wrote: >> Here's the output. >> >> # i2cdump 0 0x4c b >> WARNING! This program can confuse your I2C bus, cause data loss and >> worse! >> I will probe file /dev/i2c-0, address 0x4c, mode byte >> Continue? [Y/n] >> 0 1 2 3 4 5 6 7 8 9 a b c d e f 0123456789abcdef >> 00: 2d 37 80 01 08 46 d8 46 d8 ff ff ff ff ff ff ff -7???F?F?....... >> 10: 00 00 00 00 00 00 00 04 00 6e 6e 46 d8 00 00 ff .......?.nnF?... >> 20: 55 0a ff ff 7f e0 ff ff ff ff ff ff ff ff ff ff U?..??.......... >> 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ................ >> 40: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ................ >> 50: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ................ >> 60: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ................ >> 70: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ................ >> 80: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ................ >> 90: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ................ >> a0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ................ >> b0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff 00 ................ >> c0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ................ >> d0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ................ >> e0: 00 00 00 84 84 84 00 00 55 00 00 ff ff ff ff ff ...???..U....... >> f0: 08 00 00 00 84 00 00 36 80 fc 36 83 37 ff 5c 11 ?...?..6??6?7.\? >> >> > I hoped that someone would send >> > me a board with this chip, so that I could work on it, but it did not >> > happen. If you send me a dump of your chip, I can give it a try. >> What do you need else for working on it except the board itself? Would >> an >> account on my machine be sufficient? What command do you need to run? > > If you can rebuild a kernel with a patch applied, then you should be > able to do the tests for me. I'll post a patch in a few minutes. > > -- > Jean Delvare > Hi, I've downloaded the 2.6.33-rc4 kernel and integrated your patch. Please note, that I could not apply the patch automatically. I had to apply it by hand because the line numbers from the patch file didn't match the numbers in the target files. Which tests shall I run now? Cheers, Manuel Lamotte-Schubert _______________________________________________ lm-sensors mailing list lm-sensors@xxxxxxxxxxxxxx http://lists.lm-sensors.org/mailman/listinfo/lm-sensors
