Op 01-12-09 09:33, Samu Onkalo schreef:
Hi,
All the patches look good to me :-)
Andrew, would you mind queuing these 5 patches for 2.6.33, in addition
the ones already there?
Thanks,
Eric
Changes since v3 patch set:
0001: two if statements combined to one
0002: added "Acked by Eric Piel" to description
0003: Replaced with edited version by Eric Piel. Tested on 8 bit device
by me.
0004: Constant names changed to shorter ones. Shorter names allowed some clean
up. No functional changes
0005: added "Acked by Eric Piel" to description
Description from version 3 patch set:
This patch set is made to top of 7 previously accepted lis3 related patches in
mm-tree:
- I2C bus support for lis3lv02d and variant accelerometer chips...
- Add the possibility to remap axes via platform data...
- Send input_sync after each measurement round...
- polled input device itself was not free'd....
- riginally the driver was only targeted to 12bits sensors...
- Most of the documentation and comments were written when the driver ..
- Lis3 accelerometer sensors have quite long power on delay ..
Tested with 2.6.32-RC7 which was patched with above 7 lis3 related patches.
Tested only with 8 bit lis3 device since I don't have possibility to test other chips.
0001:
Implement selftest feature for HW diagnostic purposes. This feature can be used to detect if the sensor is electrically or mechanically damaged.
0002:
Calibration functionality is removed from the driver. Chip is allready calibrated by the manufacturer. SW calibration doesn't improve the situation.
0003:
Added possibility to set chip sampling rate. Position entry in sysfs allows reading at sampling rate.
0004:
Scale output values to mg (1/1000 of earth gravity).
Behaviour of the joystick interface is not changed. All other interfaces will have different scale after this patch. See further information from patch itself.
0005:
Update documentation to cover changes which were made by these patches.
Samu Onkalo (5):
lis3: Selftest support
LIS3LV02D: Remove calibaration functionality
lis3: Sysfs entry for setting chip measurement rate
lis3: Scale output values to mg
LIS3: Update documentation to match latest changes
Documentation/hwmon/lis3lv02d | 31 ++++++--
drivers/hwmon/lis3lv02d.c | 174 ++++++++++++++++++++++++++++++++---------
drivers/hwmon/lis3lv02d.h | 23 ++++-
include/linux/lis3lv02d.h | 3 +
4 files changed, 182 insertions(+), 49 deletions(-)
_______________________________________________
lm-sensors mailing list
lm-sensors@xxxxxxxxxxxxxx
http://lists.lm-sensors.org/mailman/listinfo/lm-sensors
