On Thu, Jun 12, 2008 at 2:30 PM, Jean Delvare <khali at linux-fr.org> wrote: >> In the output below, the value >> >> CPU Temp: -2.0?C (low = +127.0?C, high = +127.0?C) sensor = transistor >> >> seems unlikely: >> >> $ sensors >> it8712-isa-0290 >> Adapter: ISA adapter >> VCore 1: +1.28 V (min = +0.00 V, max = +4.08 V) >> VCore 2: +1.82 V (min = +0.00 V, max = +4.08 V) >> +3.3V: +3.38 V (min = +0.00 V, max = +4.08 V) >> +5V: +6.85 V (min = +0.00 V, max = +6.85 V) ALARM >> +12V: +11.84 V (min = +0.00 V, max = +16.32 V) >> -12V: -13.86 V (min = -27.36 V, max = +3.93 V) >> -5V: -7.34 V (min = -13.64 V, max = +4.03 V) >> Stdby: +6.85 V (min = +0.00 V, max = +6.85 V) ALARM >> VBat: +4.08 V >> fan1: 1704 RPM (min = 0 RPM, div = 8) >> fan2: 0 RPM (min = 0 RPM, div = 8) >> fan3: 0 RPM (min = 0 RPM, div = 8) >> M/B Temp: -55.0?C (low = +127.0?C, high = +127.0?C) sensor = transistor >> CPU Temp: -2.0?C (low = +127.0?C, high = +127.0?C) sensor = transistor >> Temp3: +47.0?C (low = +127.0?C, high = +90.0?C) sensor = thermal diode >> cpu0_vid: +1.350 V >> >> $ >> >> My motherboard is a GigaBite GA-81945PL-G, the processor is an Intel >> Dual Core, and the operating system is Fedora 9. >> >> Any ideas? > > Typical of Gigabyte boards. They put two Ethernet chips, 2 USB > controllers, Firewire, two Serial ATA controllers, etc. on the board, > but omit the thermistor for motherboard temperature to save a few > cents. Go figure... My own board (Gigabyte K8V Ultra-939) says: > > temp1: +25.0?C (low = +127.0?C, high = +127.0?C) sensor = disabled > temp2: -55.0?C (low = +127.0?C, high = +127.0?C) sensor = disabled > temp3: +47.0?C (low = +10.0?C, high = +51.0?C) sensor = thermal diode > > And temp1 never changes. So, same as yours: temp3 is the CPU > temperature, and temp1 and temp2 can be ignored (and even disabled). > The relevant part of my configuration file is: > > ### Temperatures > > # Gigabyte confirmed that there is no system temperature sensor on this > # motherboard. This is really disappointing, as the board is otherwise > # full featured. > > ignore temp1 > ignore temp2 > label temp3 "CPU Temp" > > set temp1_type 0 > set temp2_type 0 > > # The CPU temperature was seen from 34 to 48 degrees C so far. > set temp3_min 10 > set temp3_max 51 > > Hope that helps, Thanks, Jean. Now I know (from you) that temp3, in my case, corresponds to the CPU temperature. Paul
