Hello,
I have an old linux box with Winbond w83627hf chip,
and I'm trying to read the system health values.
I'm using 2.6.12, and lm_sensor3.0.1.
I ran the sensor-detect, and loaded the required
modules, "i2c-isa", and "w83627hf", and I can see the
entries in the "sys" file system.
Whatever I do (modify the label name, etc) with the
configuration file, "sensors" isn't reading from it at
all. If I comment the chip name, and run "sensors -s",
it complains - otherwise it doesn't appear to read the
config file at all. "sensors" runs fine.
But, "sensors" divides all the voltages (in0_input,
in1_input, ...) by 1000, and prints them.
"sensors" even works without the config file
(/etc/sensors.conf)
I really appreciate if someone helps me understand
what's going on.
Thanks!
