Hi J?rgen, > Hi Jean, > i have now applied the patches you told me. > > "sensors" shows now: > > snip ==================== > it8716-isa-0290 > Adapter: ISA adapter > VCore: +1.01 V (min = +0.00 V, max = +4.08 V) > +3.3V: +3.22 V (min = +0.00 V, max = +4.08 V) > +5V: +4.81 V (min = +0.00 V, max = +6.85 V) > +12V: +11.46 V (min = +0.00 V, max = +16.32 V) > 5VSB: +4.78 V (min = +0.00 V, max = +6.85 V) > VBat: +2.93 V > CPU_Fan: 2102 RPM (min = 0 RPM) > CHA_Fan1: 1254 RPM (min = 0 RPM) > PWR_Fan: 920 RPM (min = 0 RPM) > CPU Temp: +22?C (low = -1?C, high = +127?C) sensor = diode > MB Temp: +29?C (low = -1?C, high = +127?C) sensor = thermistor > vid: +1.10 V > > k8temp-pci-00c3 > Adapter: PCI adapter > temp1: +30?C > temp3: +21?C > snap==================== > > Vid looks now better. Yep, looks alright to me now :) You're lucky, out of 4 boards with the IT8716F chip, this is the only one with valid VID readings... > Ok now with the patches, two EEPROMS and some other devices were found... > What devices are at address 0x08, 0x0c, 0x22, 0x2e, 0x30, 0x31 and 0x50 ?? > Is there an device for the other fan's ? The chip at 0x2e is most certainly a second hardware monitoring chip. I just found out that the Asus M2N32-SLI has an Analog Devices ADT7475 for the additional fans, I would suspect that your board are the same or a very similar chip. I added detection of a bunch of new Analog Devices chips to sensors-detect a few minutes ago, can you please fetch it, give it a try and report? > # Warning: the required module k8temp is not currently installed on your system. > # For status of 2.6 kernel ports see http://www.lm-sensors.org/wiki/SupportedDevices > # If driver is built-in to the kernel, or unavailable, comment out the following line. > modprobe k8temp For this one you can pick these patches: http://khali.linux-fr.org/devel/i2c/linux-2.6/hwmon-k8temp-new-driver.patch http://khali.linux-fr.org/devel/i2c/linux-2.6/hwmon-k8temp-autoload.patch Thanks, -- Jean Delvare