This board does some things a bit different and does not monitor some
voltages. sensors.conf block for it follows.
Regards,
Arno
----
root /etc>sensors --version
sensors version 2.9.1 with libsensors version 2.9.1
root /etc>
----
chip "it87-*" "it8712-*"
# The values below have been tested on Asus CUSI, CUM motherboards.
# A7V880 (Asus) by Arno Wagner <arno at wagner.name>
# Comment all other entries in this section when using this
# Assumes a 1.65V CPU
label in0 "VCore 1"
label in1 "VCore 2"
label in2 "+3.3V"
label in3 "+5V"
label in4 "+12V"
label in5 "-12V"
label in6 "-5V"
label in7 "Stdby"
label in8 "VBat"
# in0 CPU core voltage VCore
compute in0 -0.05+@ , @+0.05 # VCore is displayed 0.05V too high
set in0_min 1.65 * 0.95 # Nominal 1.65V
set in0_max 1.65 * 1.05 # Nominal 1.65V
# in1 not connected to anything
ignore in1
# in2 +3.3V, take directly
set in2_min 3.3 * 0.95
set in2_max 3.3 * 1.05
# in3 +5V
compute in3 ((6.8/10)+1)*@ , @/((6.8/10)+1)
set in3_min 5 * 0.95
set in3_max 5 * 1.05
# in4 +12V
compute in4 ((30/10) +1)*@ , @/((30/10) +1)
set in4_min 12 * 0.95
set in4_max 12 * 1.05
# in5 not connected to anything
ignore in5
# in6 not connected to anything
ignore in6
# in7 not connected to anything
ignore in7
# in8 Battery, measure directly, no min/max checks
# CPU temperature
label temp1 "CPU Temp"
set temp1_over 45
set temp1_low 0
# Mainboard temperature
label temp2 "M/B Temp"
set temp2_over 40
set temp2_low 0
# temp3 is unused
ignore temp3
set fan1_min 1200
set fan2_min 1200
ignore fan3
# A7V880 end
--
Arno Wagner, Dipl. Inform., CISSP --- CSG, ETH Zurich, wagner at tik.ee.ethz.ch
GnuPG: ID: 1E25338F FP: 0C30 5782 9D93 F785 E79C 0296 797F 6B50 1E25 338F
----
Cuddly UI's are the manifestation of wishful thinking. -- Dylan Evans
Windows is the "under-3" toy of the OS world. -- Matthew D. Fuller
