[grin] I've been there and done that as well... Looks great! :v) Aurelien Jarno wrote: >On Mon, May 10, 2004 at 10:14:44AM -0700, Philip Pokorny wrote: > > >>That's great, but I think you missed one: >> >>@@ -312,6 +325,8 @@ >># the CPU temperature. >># label temp "M/B Temp" >> >>+# Uncomment the following line to enable all beeping globally >>+# set beep_enable 1 >> >>chip "lm75-*" >> >> > >That's because I am the specialist of broken patches or patches with >problems... In almost all cases, I need to send a patch three times >until it is correct :-) > >New patch attached, hope this time it will be ok. > > > > >------------------------------------------------------------------------ > >diff -urN lm_sensors2.orig/etc/sensors.conf.eg lm_sensors2/etc/sensors.conf.eg >--- lm_sensors2.orig/etc/sensors.conf.eg 2004-05-11 02:12:44.000000000 +0200 >+++ lm_sensors2/etc/sensors.conf.eg 2004-05-11 02:12:36.000000000 +0200 >@@ -221,6 +221,19 @@ > # yet supported; spaces at the end are ignored, though. > # > # >+# BEEPS >+# ----- >+# Some chips support alarms with beep warnings. When an alarm is triggered >+# you can be warned by a beeping signal through your computer speaker. It >+# is possible to enable beeps for all alarms on a chip using the following >+# line: >+# >+# set beep_enable 1 >+# >+# or disable them using: >+# >+# set beep_enable 0 >+# > ########################################################################## > #### Here begins the real configuration file > >@@ -312,6 +325,9 @@ > # the CPU temperature. > # label temp "M/B Temp" > >+# Uncomment the following line to enable beeps for all alarms on this chip >+# set beep_enable 1 >+ > > chip "lm75-*" > > > -- Philip Pokorny, Director of Engineering Tel: 415-954-2823 Fax: 415-954-2899 Toll Free: 888-PENGUIN PENGUIN COMPUTING, INC. www.penguincomputing.com
