Hello- sensors-detect tells me I have and adm1021 sensor. When I try to load this module, my monitor turns off, and the hard drive light stays on until I shut down and unplug the machine from the wall for several seconds. Merely powering off does not help. I don't know if this is a bad detection or a hardware issue. I also have a W83682HF chip on the mobo which works fine, as well as the eeprom driver. It may be of interest to note that the new radeonfb driver includes an i2c interface which is detected by sensors-detect and the i2c interface itself is detected by the radeonfb driver. If there is any output you would like, or investigation I can do to help, let me know. Please respond to: douglassac at earthlink.net Thanks -Chris My hardware is: ABIT NF7-S 2.0 BIOS 21 Radeon 9700 Pro Software: Slackware 9.1 kernel 2.6.3 lm_sensors2 CVS checked out on 2/25/04 -- -- -------------- next part -------------- An HTML attachment was scrubbed... URL: http://lists.lm-sensors.org/pipermail/lm-sensors/attachments/20040227/640b42f5/attachment.html
