Hi,
Does RivaTV work with 2.6? I get:
Checking for kernel dependancies... not found
*** WARNING:
*** Your kernel dependancies are not set up.
*** Please run "make dep" in /lib/modules/2.6.0-mywin4lin/build
On ./configure, and make dep just says that is no longer neccesary. The RivaTV
site doesn't seem to mention anything about 2.6, and make/make install
doesn't work properly.
Regards,
-Colin
PS: sensors-detect never did anything before besides detect the one sensor on
my motherboard (which works great!), and i2cdetect didn't show the bus, it
just did:
[root at localhost rivatv-0.8.3]# i2cdetect
Syntax: i2cdetect I2CBUS
I2CBUS is an integer
i2cdetect -l lists installed busses only
Installed I2C busses:
i2c-1 dummy ISA main adapter ISA
bus algorithm
i2c-0 unknown SMBus I801 adapter at 0400
Algorithm unavailable
The device never came up at address 0x2d (which is its I2C address), until
after I patched the device onto the I2C bus on the motherboard (neither of
those buses appear to be the video card one...)
PPS: Here is the output of the two commands at any rate:
[root at localhost rivatv-0.8.3]# lspci -v
00:00.0 Host bridge: Intel Corp. 82875P Memory Controller Hub (rev 02)
Subsystem: Asustek Computer, Inc.: Unknown device 80f6
Flags: bus master, fast devsel, latency 0
Memory at f4000000 (32-bit, prefetchable) [size=64M]
Capabilities: [e4] #09 [2106]
Capabilities: [a0] AGP version 3.0
00:01.0 PCI bridge: Intel Corp. 82875P Processor to AGP Controller (rev 02)
(prog-if 00 [Normal decode])
Flags: bus master, 66Mhz, fast devsel, latency 64
Bus: primary=00, secondary=01, subordinate=01, sec-latency=64
Memory behind bridge: fc900000-fe9fffff
Prefetchable memory behind bridge: cff00000-efefffff
00:1d.0 USB Controller: Intel Corp. 82801EB USB (rev 02) (prog-if 00 [UHCI])
Subsystem: Asustek Computer, Inc.: Unknown device 80a6
Flags: bus master, medium devsel, latency 0, IRQ 10
I/O ports at ef00 [size=32]
00:1d.1 USB Controller: Intel Corp. 82801EB USB (rev 02) (prog-if 00 [UHCI])
Subsystem: Asustek Computer, Inc.: Unknown device 80a6
Flags: bus master, medium devsel, latency 0, IRQ 5
I/O ports at ef20 [size=32]
00:1d.2 USB Controller: Intel Corp. 82801EB USB (rev 02) (prog-if 00 [UHCI])
Subsystem: Asustek Computer, Inc.: Unknown device 80a6
Flags: bus master, medium devsel, latency 0, IRQ 5
I/O ports at ef40 [size=32]
00:1d.3 USB Controller: Intel Corp. 82801EB USB (rev 02) (prog-if 00 [UHCI])
Subsystem: Asustek Computer, Inc.: Unknown device 80a6
Flags: bus master, medium devsel, latency 0, IRQ 10
I/O ports at ef80 [size=32]
00:1d.7 USB Controller: Intel Corp. 82801EB USB2 (rev 02) (prog-if 20 [EHCI])
Subsystem: Asustek Computer, Inc.: Unknown device 80a6
Flags: bus master, medium devsel, latency 0, IRQ 11
Memory at febffc00 (32-bit, non-prefetchable) [size=1K]
Capabilities: [50] Power Management version 2
Capabilities: [58] #0a [20a0]
00:1e.0 PCI bridge: Intel Corp. 82801BA/CA/DB/EB PCI Bridge (rev c2) (prog-if
00 [Normal decode])
Flags: bus master, fast devsel, latency 0
Bus: primary=00, secondary=02, subordinate=02, sec-latency=64
I/O behind bridge: 0000d000-0000dfff
Memory behind bridge: fea00000-feafffff
00:1f.0 ISA bridge: Intel Corp. 82801EB LPC Interface Controller (rev 02)
Flags: bus master, medium devsel, latency 0
00:1f.1 IDE interface: Intel Corp. 82801EB Ultra ATA Storage Controller (rev
02) (prog-if 8a [Master SecP PriP])
Subsystem: Asustek Computer, Inc.: Unknown device 80a6
Flags: bus master, medium devsel, latency 0
I/O ports at <unassigned>
I/O ports at <unassigned>
I/O ports at <unassigned>
I/O ports at <unassigned>
I/O ports at fc00 [size=16]
Memory at 40000000 (32-bit, non-prefetchable) [size=1K]
00:1f.2 IDE interface: Intel Corp. 82801EB Ultra ATA Storage Controller (rev
02) (prog-if 8f [Master SecP SecO PriP PriO])
Subsystem: Asustek Computer, Inc.: Unknown device 80a6
Flags: bus master, 66Mhz, medium devsel, latency 0, IRQ 5
I/O ports at efe0 [size=8]
I/O ports at efac [size=4]
I/O ports at efa0 [size=8]
I/O ports at efa8 [size=4]
I/O ports at ef60 [size=16]
00:1f.3 SMBus: Intel Corp. 82801EB SMBus Controller (rev 02)
Subsystem: Asustek Computer, Inc.: Unknown device 80a6
Flags: medium devsel, IRQ 10
I/O ports at 0400 [size=32]
01:00.0 VGA compatible controller: nVidia Corporation NV31 [GeForce FX 5600]
(rev a1) (prog-if 00 [VGA])
Subsystem: Micro-Star International Co., Ltd.: Unknown device 9126
Flags: bus master, 66Mhz, medium devsel, latency 248, IRQ 10
Memory at fd000000 (32-bit, non-prefetchable) [size=16M]
Memory at d0000000 (32-bit, prefetchable) [size=256M]
Expansion ROM at fe9e0000 [disabled] [size=128K]
Capabilities: [60] Power Management version 2
Capabilities: [44] AGP version 3.0
02:03.0 FireWire (IEEE 1394): VIA Technologies, Inc. IEEE 1394 Host Controller
(rev 80) (prog-if 10 [OHCI])
Subsystem: Asustek Computer, Inc.: Unknown device 808a
Flags: bus master, medium devsel, latency 64, IRQ 10
Memory at feaff800 (32-bit, non-prefetchable) [size=2K]
I/O ports at dc00 [size=128]
Capabilities: [50] Power Management version 2
02:05.0 Ethernet controller: 3Com Corporation 3c940 1000Base? (rev 12)
Subsystem: Asustek Computer, Inc.: Unknown device 80eb
Flags: bus master, 66Mhz, medium devsel, latency 64, IRQ 10
Memory at feaf8000 (32-bit, non-prefetchable) [size=16K]
I/O ports at d800 [size=256]
Capabilities: [48] Power Management version 2
Capabilities: [50] Vital Product Data
02:0b.0 Multimedia audio controller: Creative Labs SB Live! EMU10k1 (rev 08)
Subsystem: Creative Labs SB Live! 5.1 Model SB0100
Flags: bus master, medium devsel, latency 64, IRQ 11
I/O ports at df80 [size=32]
Capabilities: [dc] Power Management version 2
02:0b.1 Input device controller: Creative Labs SB Live! MIDI/Game Port (rev
08)
Subsystem: Creative Labs Gameport Joystick
Flags: bus master, medium devsel, latency 64
I/O ports at dfe0 [size=8]
Capabilities: [dc] Power Management version 2
[root at localhost rivatv-0.8.3]# lspci -n
00:00.0 Class 0600: 8086:2578 (rev 02)
00:01.0 Class 0604: 8086:2579 (rev 02)
00:1d.0 Class 0c03: 8086:24d2 (rev 02)
00:1d.1 Class 0c03: 8086:24d4 (rev 02)
00:1d.2 Class 0c03: 8086:24d7 (rev 02)
00:1d.3 Class 0c03: 8086:24de (rev 02)
00:1d.7 Class 0c03: 8086:24dd (rev 02)
00:1e.0 Class 0604: 8086:244e (rev c2)
00:1f.0 Class 0601: 8086:24d0 (rev 02)
00:1f.1 Class 0101: 8086:24db (rev 02)
00:1f.2 Class 0101: 8086:24d1 (rev 02)
00:1f.3 Class 0c05: 8086:24d3 (rev 02)
01:00.0 Class 0300: 10de:0312 (rev a1)
02:03.0 Class 0c00: 1106:3044 (rev 80)
02:05.0 Class 0200: 10b7:1700 (rev 12)
02:0b.0 Class 0401: 1102:0002 (rev 08)
02:0b.1 Class 0980: 1102:7002 (rev 08)
On February 21, 2004 04:13 pm, Jean Delvare wrote:
> > Did you try
> > http://rivatv.sourceforge.net/download.html
> >
> > It should have a driver called
> >
> > i2c-riva
>
> Since some times now, they have a single module for everything
> (including i2c), so it is called rivatv.
>
> > so you dont need to override the bus.
> > It will create new bus with hopefully this device too.
>
> Yes, it should.
>
> A recent version of sensors-detect *should* also have detected it and
> suggest that you go and get the above-mentioned module. Colin, didn't
> that happen? If it did not, please provide the output of lspci -v and
> lspci -n so that we can add your card to the list.
>
> Thanks.
