You might also try placing a shorting jumper over the intrusion detection pins on the motherboard to prevent the alarm in the future. :v) John Hearns wrote: >Dear all, >can I ask for a little help please? >I am trying to configure lm_sensors for a dual processor >Supermicro motherboard. > >I'm using the Nagios plugin check_sensors, >which very simply does a grep on the output of sensors, >and returns an alarm sate if the string ALARM is present. >On this motherboard, the chassis intrusion alarm is often set, >and I'd rather not alarm on this. > >Is there a way of switching off this alarm in sensors.conf please? > > >Here is the sensors output below. > > > > > >max1617-i2c-0-1a >Adapter: SMBus I801 adapter at 1100 >Algorithm: Non-I2C SMBus adapter >Board: +29???C (min = +20???C, max = +60???C) >CPU: +32???C (min = +20???C, max = +60???C) > >w83627hf-i2c-0-2d >Adapter: SMBus I801 adapter at 1100 >Algorithm: Non-I2C SMBus adapter >VCore 1: +1.47 V (min = +4.08 V, max = +4.08 V) >VCore 2: +3.32 V (min = +4.08 V, max = +4.08 V) >+3.3V: +3.31 V (min = +2.97 V, max = +3.63 V) >+5V: +4.97 V (min = +4.50 V, max = +5.48 V) >+12V: +11.86 V (min = +10.79 V, max = +13.11 V) >-12V: -11.41 V (min = -13.21 V, max = -10.90 V) >-5V: -2.00 V (min = -5.51 V, max = -4.51 V) >V5SB: +5.51 V (min = +4.50 V, max = +5.48 V) >VBat: +3.24 V (min = +2.70 V, max = +3.29 V) >fan1: 4787 RPM (min = 3000 RPM, div = 2) >fan2: 4753 RPM (min = 3000 RPM, div = 2) >fan3: 0 RPM (min = 750 RPM, div = 8) >temp1: +36???C (limit = +60???C) sensor = >thermistor >temp2: +30.0???C (limit = +60???C, hysteresis = +50???C) sensor = >thermistor >temp3: +30.0???C (limit = +60???C, hysteresis = +50???C) sensor = >thermistor >vid: +1.400 V >alarms: Chassis intrusion detection ALARM >beep_enable: > Sound alarm disabled > > > > > >
