These guys (and lady, for that matter) have a real support service! That's really great :) Begin forwarded message: Date: Tue, 29 Jul 2003 12:53:17 +0100 From: "Burke, Mary" <Mary.Burke at analog.com> To: <khali at linux-fr.org> Subject: RE: ADM1025 documentation Hi Jean Thanks for the feedback. I will include those edits in the next revision Thanks and Regards Mary -----Original Message----- From: Jean Delvare [mailto:khali at linux-fr.org] Sent: 28 July 2003 16:54 To: Burke, Mary Cc: LM Sensors Subject: ADM1025 documentation Hi Mary, While working on our Linux driver for the ADM1025 today, I noticed a pair of errors or inconsistencies in the ADM1025 datasheet (revision C). I thought you would want us to report so that they can be fixed in the next revision. 1* The description of pin 16 (in the Pin Function Descriptions table, page 4) make the reader think that only the lowest order bit of the I2C address can be changed, while the last *two* bits can be (three possible addresses total). 2* It isn't very clear that the reference value for VCCP is 2.25V. I first thought it was depending on the actual VID value. I could figure out the truth by reading table II (A/D Output Codes vs. Vin, page 9) but I think it should be more explicit. 3* In table X (page 15), bit 6 description, typo found: "tHhe" should be "the". Thanks for your support! :) -- Jean Delvare http://www.ensicaen.ismra.fr/~delvare/ -- Jean Delvare http://www.ensicaen.ismra.fr/~delvare/
