Mark D. Studebaker wrote:
> Your 83697 must be on the isa bus so you don't need
> the CVS version of i2c-viapro to access it.
> To force on the isa bus use the special bus number 9191:
> 'modprobe w83781d force_w83697hf=9191,0xXXX' where
> XXX is probably 290 but check the output of sensors-detect
> to see where it found it.
Ah, thanks!
After a couple of days (and since I ended up having to load some
cvs modules to get my Audigy card somewhat working; Ah, life on
the bleedin' edge :>), I went ahead and loaded the i2c & lm_sensors
CVS modules.
It did give me some more info to work with, and now I can look at
my eeproms (I dont know why, but...). But perhaps I was misled
or misinterpreted the `more info' ! It seemed to indicate I should
use
modprobe w83781d force_w83627hf=0,0x69
which _did_ give me apparent sensors output, but all the numbers
were nonsense, eg, the fan was running at an impressive 37500 rpm!
Wow! and all min & max were the same as the values.....
I just tried your suggestion (and indeed 290 is where sensors-detect
had found the chip) [I could have sworn that I tried this before...]
At any rate, now I'm getting mostly sensible (see below)
A few inputs I'm pretty sure aren't hooked up (fan2,fan3,temp3, Vcore2?)
A couple of others look worrisome (VCore1, +3.3V, -12V, -5V), but
perhaps the conversion parameters need tweeking for the w83697hf ?
If anybody knows the needed tweaks, I'd appreciate it; otherwise, I'll
eventually grope around and try to figure it out.
At any rate, I'm much closer; Thanks!!!
w83627hf-isa-0290
Adapter: ISA adapter
Algorithm: ISA algorithm
VCore 1: +1.77 V (min = +1.23 V, max = +1.36 V)
VCore 2: +0.00 V (min = +1.23 V, max = +1.36 V)
+3.3V: +1.52 V (min = +3.13 V, max = +3.45 V)
+5V: +4.89 V (min = +4.72 V, max = +5.24 V)
+12V: +12.39 V (min = +10.79 V, max = +13.19 V)
-12V: +1.95 V (min = -10.90 V, max = -13.21 V)
-5V: +0.61 V (min = -4.76 V, max = -5.26 V)
V5SB: +5.58 V (min = +4.72 V, max = +5.24 V)
VBat: +3.08 V (min = +2.40 V, max = +3.60 V)
fan1: 4891 RPM (min = 3000 RPM, div = 2)
fan2: 0 RPM (min = 3000 RPM, div = 2)
fan3: 0 RPM (min = 3000 RPM, div = 2)
temp1: +77?F (limit = +140?F, hysteresis = +122?F) sensor =
thermistor
temp2: +114.8?F (limit = +140?F, hysteresis = +122?F) sensor =
thermistor
temp3: +491.9?F (limit = +492?F, hysteresis = +492?F) sensor =
thermistor
vid: +1.30 V
alarms: Chassis intrusion detection
beep_enable:
Sound alarm disabled
