For I/O to reflinked blocks we always need to write an entire new file system block, and the code enforces the file system block alignment for the entire file if it has any reflinked blocks. Use the new STATX_DIO_READ_ALIGN flag to report the asymmetric read vs write alignments for reflinked files. Signed-off-by: Christoph Hellwig <hch@xxxxxx> Reviewed-by: "Darrick J. Wong" <djwong@xxxxxxxxxx> --- fs/xfs/xfs_iops.c | 21 ++++++++++++++++++--- 1 file changed, 18 insertions(+), 3 deletions(-) diff --git a/fs/xfs/xfs_iops.c b/fs/xfs/xfs_iops.c index 6b0228a21617..40289fe6f5b2 100644 --- a/fs/xfs/xfs_iops.c +++ b/fs/xfs/xfs_iops.c @@ -580,9 +580,24 @@ xfs_report_dioalign( struct xfs_buftarg *target = xfs_inode_buftarg(ip); struct block_device *bdev = target->bt_bdev; - stat->result_mask |= STATX_DIOALIGN; + stat->result_mask |= STATX_DIOALIGN | STATX_DIO_READ_ALIGN; stat->dio_mem_align = bdev_dma_alignment(bdev) + 1; - stat->dio_offset_align = bdev_logical_block_size(bdev); + + /* + * For COW inodes, we can only perform out of place writes of entire + * allocation units (blocks or RT extents). + * For writes smaller than the allocation unit, we must fall back to + * buffered I/O to perform read-modify-write cycles. At best this is + * highly inefficient; at worst it leads to page cache invalidation + * races. Tell applications to avoid this by reporting the larger write + * alignment in dio_offset_align, and the smaller read alignment in + * dio_read_offset_align. + */ + stat->dio_read_offset_align = bdev_logical_block_size(bdev); + if (xfs_is_cow_inode(ip)) + stat->dio_offset_align = xfs_inode_alloc_unitsize(ip); + else + stat->dio_offset_align = stat->dio_read_offset_align; } static void @@ -658,7 +673,7 @@ xfs_vn_getattr( stat->rdev = inode->i_rdev; break; case S_IFREG: - if (request_mask & STATX_DIOALIGN) + if (request_mask & (STATX_DIOALIGN | STATX_DIO_READ_ALIGN)) xfs_report_dioalign(ip, stat); if (request_mask & STATX_WRITE_ATOMIC) xfs_report_atomic_write(ip, stat); -- 2.45.2
