Hi, ShiYang,
So I applied the v6 patch series to my 5.14-rc3 as it's what you
indicated is what v6 was based at, and injected a hardware poison.
I'm seeing the same problem that was reported a while ago after the
poison was consumed - in the SIGBUS payload, the si_addr is missing:
** SIGBUS(7): canjmp=1, whichstep=0, **
** si_addr(0x(nil)), si_lsb(0xC), si_code(0x4, BUS_MCEERR_AR) **
The si_addr ought to be 0x7f6568000000 - the vaddr of the first page
in this case.
Something is not right...
thanks,
-jane
On 8/5/2021 6:17 PM, Jane Chu wrote:
The filesystem part of the pmem failure handling is at minimum built
on PAGE_SIZE granularity - an inheritance from general memory_failure
handling. However, with Intel's DCPMEM technology, the error blast
radius is no more than 256bytes, and might get smaller with future
hardware generation, also advanced atomic 64B write to clear the poison.
But I don't see any of that could be incorporated in, given that the
filesystem is notified a corruption with pfn, rather than an exact
address.
So I guess this question is also for Dan: how to avoid unnecessarily
repairing a PMD range for a 256B corrupt range going forward?
thanks,
-jane
On 7/30/2021 3:01 AM, Shiyang Ruan wrote:
When memory-failure occurs, we call this function which is implemented
by each kind of devices. For the fsdax case, pmem device driver
implements it. Pmem device driver will find out the filesystem in which
the corrupted page located in. And finally call filesystem handler to
deal with this error.
The filesystem will try to recover the corrupted data if necessary.
