Re: [PATCH v2] iomap: zero cached page over unwritten extent on truncate page

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Wed, Oct 21, 2020 at 09:33:29AM -0400, Brian Foster wrote:
> iomap_truncate_page() relies on zero range and zero range
> unconditionally skips unwritten mappings. This is normally not a
> problem as most users synchronize in-core state to the underlying
> block mapping by flushing pagecache prior to calling into iomap.
> This is not the case for iomap_truncate_page(), however. XFS calls
> iomap_truncate_page() on truncate down before flushing the new EOF
> page of the file. This means that if the new EOF block is unwritten
> but covered by a dirty or writeback page (i.e. awaiting unwritten
> conversion after writeback), iomap fails to zero that page. The
> subsequent truncate_setsize() call does perform page zeroing, but
> doesn't dirty the page. Therefore if the new EOF page is written
> back after calling into iomap but before the pagecache truncate, the
> post-EOF zeroing is lost on page reclaim. This exposes stale
> post-EOF data on mapped reads.
> 
> Rework iomap_truncate_page() to check pagecache state before calling
> into iomap_apply() and use that info to determine whether we can
> safely skip zeroing unwritten extents. The filesystem has locked out
> concurrent I/O and mapped operations at this point but is not
> serialized against writeback, unwritten extent conversion (I/O
> completion) or page reclaim. Therefore if a page does not exist
> before we acquire the mapping, we can be certain that an unwritten
> extent cannot be converted before we return and thus it is safe to
> skip. If a page does exist over an unwritten block, it could be in
> the dirty or writeback states, convert the underlying mapping at any
> time, and thus should be explicitly written to avoid racing with
> writeback. Finally, since iomap_truncate_page() only targets the new
> EOF block and must now pass additional state to the actor, open code
> the zeroing actor instead of plumbing through zero range.
> 
> This does have the tradeoff that an existing clean page is dirtied
> and causes unwritten conversion, but this is analogous to historical
> behavior implemented by block_truncate_page(). This patch restores
> historical behavior to address the data exposure problem and leaves
> filtering out the clean page case for a separate patch.
> Fixes: 68a9f5e7007c ("xfs: implement iomap based buffered write path")
> Signed-off-by: Brian Foster <bfoster@xxxxxxxxxx>
> ---
> 
> v2:
> - Rework to check for cached page explicitly and avoid use of seek data.
> v1: https://lore.kernel.org/linux-fsdevel/20201012140350.950064-1-bfoster@xxxxxxxxxx/

Has the reproducer listed in that email been turned into a fstest case
yet? :)

> 
>  fs/iomap/buffered-io.c | 41 ++++++++++++++++++++++++++++++++++++++++-
>  1 file changed, 40 insertions(+), 1 deletion(-)
> 
> diff --git a/fs/iomap/buffered-io.c b/fs/iomap/buffered-io.c
> index bcfc288dba3f..2cdfcff02307 100644
> --- a/fs/iomap/buffered-io.c
> +++ b/fs/iomap/buffered-io.c
> @@ -1000,17 +1000,56 @@ iomap_zero_range(struct inode *inode, loff_t pos, loff_t len, bool *did_zero,
>  }
>  EXPORT_SYMBOL_GPL(iomap_zero_range);
>  
> +struct iomap_trunc_priv {
> +	bool *did_zero;
> +	bool has_page;
> +};
> +
> +static loff_t
> +iomap_truncate_page_actor(struct inode *inode, loff_t pos, loff_t count,
> +		void *data, struct iomap *iomap, struct iomap *srcmap)
> +{
> +	struct iomap_trunc_priv	*priv = data;
> +	unsigned offset;
> +	int status;
> +
> +	if (srcmap->type == IOMAP_HOLE)
> +		return count;
> +	if (srcmap->type == IOMAP_UNWRITTEN && !priv->has_page)
> +		return count;
> +
> +	offset = offset_in_page(pos);
> +	if (IS_DAX(inode))
> +		status = dax_iomap_zero(pos, offset, count, iomap);
> +	else
> +		status = iomap_zero(inode, pos, offset, count, iomap, srcmap);
> +	if (status < 0)
> +		return status;
> +
> +	if (priv->did_zero)
> +		*priv->did_zero = true;
> +	return count;
> +}
> +
>  int
>  iomap_truncate_page(struct inode *inode, loff_t pos, bool *did_zero,
>  		const struct iomap_ops *ops)
>  {
> +	struct iomap_trunc_priv priv = { .did_zero = did_zero };
>  	unsigned int blocksize = i_blocksize(inode);
>  	unsigned int off = pos & (blocksize - 1);
> +	loff_t ret;
>  
>  	/* Block boundary? Nothing to do */
>  	if (!off)
>  		return 0;
> -	return iomap_zero_range(inode, pos, blocksize - off, did_zero, ops);
> +
> +	priv.has_page = filemap_range_has_page(inode->i_mapping, pos, pos);

Er... shouldn't that second 'pos' be 'pos + blocksize - off - 1', like
the apply call below?  I guess it doesn't matter since we're only
interested in the page at pos, but the double usage of pos caught my
eye.

I also wonder, can you move this into the actor so that you can pass
*did_zero straight through without the two-item struct?

--D

> +	ret = iomap_apply(inode, pos, blocksize - off, IOMAP_ZERO, ops, &priv,
> +			  iomap_truncate_page_actor);
> +	if (ret <= 0)
> +		return ret;
> +	return 0;
>  }
>  EXPORT_SYMBOL_GPL(iomap_truncate_page);
>  
> -- 
> 2.25.4
> 



[Index of Archives]     [XFS Filesystem Development (older mail)]     [Linux Filesystem Development]     [Linux Audio Users]     [Yosemite Trails]     [Linux Kernel]     [Linux RAID]     [Linux SCSI]


  Powered by Linux