On Sun, Jun 3, 2018 at 5:25 PM, Dave Chinner <david@xxxxxxxxxxxxx> wrote: > On Mon, Jun 04, 2018 at 08:20:38AM +1000, Dave Chinner wrote: >> On Thu, May 31, 2018 at 09:02:52PM -0700, Dan Williams wrote: >> > On Thu, May 31, 2018 at 7:24 PM, Dave Chinner <david@xxxxxxxxxxxxx> wrote: >> > > On Thu, May 31, 2018 at 06:57:33PM -0700, Dan Williams wrote: >> > >> > FWIW, XFS+DAX used to just work on this setup (I hadn't even >> > >> > installed ndctl until this morning!) but after changing the kernel >> > >> > it no longer works. That would make it a regression, yes? >> >> [....] >> >> > >> I suspect your kernel does not have CONFIG_ZONE_DEVICE enabled which >> > >> has the following dependencies: >> > >> >> > >> depends on MEMORY_HOTPLUG >> > >> depends on MEMORY_HOTREMOVE >> > >> depends on SPARSEMEM_VMEMMAP >> > > >> > > Filesystem DAX now has a dependency on memory hotplug? >> >> [....] >> >> > > OK, works now I've found the magic config incantantions to turn >> > > everything I now need on. >> >> By enabling these options, my test VM now has a ~30s pause in the >> boot very soon after the nvdimm subsystem is initialised. >> >> [ 1.523718] Serial: 8250/16550 driver, 4 ports, IRQ sharing enabled >> [ 1.550353] 00:05: ttyS0 at I/O 0x3f8 (irq = 4, base_baud = 115200) is a 16550A >> [ 1.552175] Non-volatile memory driver v1.3 >> [ 2.332045] tsc: Refined TSC clocksource calibration: 2199.909 MHz >> [ 2.333280] clocksource: tsc: mask: 0xffffffffffffffff max_cycles: 0x1fb5dcd4620, max_idle_ns: 440795264143 ns >> [ 37.217453] brd: module loaded >> [ 37.225423] loop: module loaded >> [ 37.228441] virtio_blk virtio2: [vda] 10485760 512-byte logical blocks (5.37 GB/5.00 GiB) >> [ 37.245418] virtio_blk virtio3: [vdb] 146800640 512-byte logical blocks (75.2 GB/70.0 GiB) >> [ 37.255794] virtio_blk virtio4: [vdc] 1073741824000 512-byte logical blocks (550 TB/500 TiB) >> [ 37.265403] nd_pmem namespace1.0: unable to guarantee persistence of writes >> [ 37.265618] nd_pmem namespace0.0: unable to guarantee persistence of writes >> >> The system does not appear to be consuming CPU, but it is blocking >> NMIs so I can't get a CPU trace. For a VM that I rely on booting in >> a few seconds because I reboot it tens of times a day, this is a >> problem.... > > And when I turn on KASAN, the kernel fails to boot to a login prompt > because: What's your qemu and kernel command line? I'll take look at this first thing tomorrow. -- To unsubscribe from this list: send the line "unsubscribe linux-xfs" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
