Hello Dmitry.
On 01.02.23 01:50, Dmitry Torokhov wrote:
On Tue, Jan 31, 2023 at 3:52 PM Dmitry Torokhov
<dmitry.torokhov@xxxxxxxxx> wrote:
Hi Arnd,
On Thu, Jan 26, 2023 at 8:32 AM Arnd Bergmann <arnd@xxxxxxxxxx> wrote:
/* Reset */
- if (gpio_is_valid(rstn)) {
+ if (rstn) {
udelay(1);
- gpio_set_value_cansleep(rstn, 0);
+ gpiod_set_value_cansleep(rstn, 0);
udelay(1);
- gpio_set_value_cansleep(rstn, 1);
+ gpiod_set_value_cansleep(rstn, 1);
For gpiod conversions, if we are not willing to chase whether existing
DTSes specify polarities
properly and create workarounds in case they are wrong, we should use
gpiod_set_raw_value*()
(my preference would be to do the work and not use "raw" variants).
In this particular case, arch/arm/boot/dts/vf610-zii-dev-rev-c.dts
defines reset line as active low,
so you are leaving the device in reset state.
Please review your other conversion patches.
We also can not change the names of requested GPIOs from "reset-gpio"
to "rstn-gpios" and expect
this to work.
Stefan, please consider reverting this and applying a couple of
patches I will send out shortly.
Thanks for having another look at these patches. Do you have the same
concern for the convesion patch to cc2520 that has been posted and
applied as well?
Arnd, if you have any concerns about the revert please speak up soon as
I am going to revert your patch and get these patches into my tree later
today.
regards
Stefan Schmidt