From: Andrey Smirnov <andrew.smirnov@xxxxxxxxx>
Driver code never touches "rstn" signal in atomic context, so there's
no need to implicitly put such restriction on it by using gpio_set_value
to manipulate it. Replace gpio_set_value to gpio_set_value_cansleep to
fix that.
As a an example of where such restriction might be inconvenient,
consider a hardware design where "rstn" is connected to a pin of I2C/SPI
GPIO expander chip.
Cc: Chris Healy <cphealy@xxxxxxxxx>
Signed-off-by: Andrey Smirnov <andrew.smirnov@xxxxxxxxx>
Signed-off-by: Stefan Schmidt <stefan@xxxxxxxxxxxxxxx>
---
drivers/net/ieee802154/at86rf230.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/drivers/net/ieee802154/at86rf230.c b/drivers/net/ieee802154/at86rf230.c
index 46d53a6..76ba7ec 100644
--- a/drivers/net/ieee802154/at86rf230.c
+++ b/drivers/net/ieee802154/at86rf230.c
@@ -1715,9 +1715,9 @@ static int at86rf230_probe(struct spi_device *spi)
/* Reset */
if (gpio_is_valid(rstn)) {
udelay(1);
- gpio_set_value(rstn, 0);
+ gpio_set_value_cansleep(rstn, 0);
udelay(1);
- gpio_set_value(rstn, 1);
+ gpio_set_value_cansleep(rstn, 1);
usleep_range(120, 240);
}
--
2.5.5
--
To unsubscribe from this list: send the line "unsubscribe linux-wpan" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
