For supporting regmap, this patch will add more register defines to prepare a full register dump by regmap debugfs. Reviewed-by: Stefan Schmidt <stefan@xxxxxxxxxxxxxxx> Signed-off-by: Alexander Aring <alex.aring@xxxxxxxxx> --- drivers/net/ieee802154/mrf24j40.c | 68 +++++++++++++++++++++++++++++++++++++++ 1 file changed, 68 insertions(+) diff --git a/drivers/net/ieee802154/mrf24j40.c b/drivers/net/ieee802154/mrf24j40.c index 80b3c6e..12f0606 100644 --- a/drivers/net/ieee802154/mrf24j40.c +++ b/drivers/net/ieee802154/mrf24j40.c @@ -29,21 +29,56 @@ #define REG_SADRL 0x03 /* Short address (low) */ #define REG_SADRH 0x04 /* Short address (high) */ #define REG_EADR0 0x05 /* Long address (low) (high is EADR7) */ +#define REG_EADR1 0x06 +#define REG_EADR2 0x07 +#define REG_EADR3 0x08 +#define REG_EADR4 0x09 +#define REG_EADR5 0x0A +#define REG_EADR6 0x0B +#define REG_EADR7 0x0C +#define REG_RXFLUSH 0x0D +#define REG_ORDER 0x10 #define REG_TXMCR 0x11 /* Transmit MAC control */ +#define REG_ACKTMOUT 0x12 +#define REG_ESLOTG1 0x13 +#define REG_SYMTICKL 0x14 +#define REG_SYMTICKH 0x15 #define REG_PACON0 0x16 /* Power Amplifier Control */ #define REG_PACON1 0x17 /* Power Amplifier Control */ #define REG_PACON2 0x18 /* Power Amplifier Control */ +#define REG_TXBCON0 0x1A #define REG_TXNCON 0x1B /* Transmit Normal FIFO Control */ +#define REG_TXG1CON 0x1C +#define REG_TXG2CON 0x1D +#define REG_ESLOTG23 0x1E +#define REG_ESLOTG45 0x1F +#define REG_ESLOTG67 0x20 +#define REG_TXPEND 0x21 +#define REG_WAKECON 0x22 +#define REG_FROMOFFSET 0x23 #define REG_TXSTAT 0x24 /* TX MAC Status Register */ +#define REG_TXBCON1 0x25 +#define REG_GATECLK 0x26 +#define REG_TXTIME 0x27 +#define REG_HSYMTMRL 0x28 +#define REG_HSYMTMRH 0x29 #define REG_SOFTRST 0x2A /* Soft Reset */ +#define REG_SECCON0 0x2C +#define REG_SECCON1 0x2D #define REG_TXSTBL 0x2E /* TX Stabilization */ +#define REG_RXSR 0x30 #define REG_INTSTAT 0x31 /* Interrupt Status */ #define REG_INTCON 0x32 /* Interrupt Control */ #define REG_GPIO 0x33 /* GPIO */ #define REG_TRISGPIO 0x34 /* GPIO direction */ +#define REG_SLPACK 0x35 #define REG_RFCTL 0x36 /* RF Control Mode Register */ +#define REG_SECCR2 0x37 +#define REG_BBREG0 0x38 #define REG_BBREG1 0x39 /* Baseband Registers */ #define REG_BBREG2 0x3A /* */ +#define REG_BBREG3 0x3B +#define REG_BBREG4 0x3C #define REG_BBREG6 0x3E /* */ #define REG_CCAEDTH 0x3F /* Energy Detection Threshold */ @@ -56,12 +91,45 @@ #define REG_RFCON6 0x206 #define REG_RFCON7 0x207 #define REG_RFCON8 0x208 +#define REG_SLPCAL0 0x209 +#define REG_SLPCAL1 0x20A +#define REG_SLPCAL2 0x20B +#define REG_RFSTATE 0x20F #define REG_RSSI 0x210 #define REG_SLPCON0 0x211 /* Sleep Clock Control Registers */ #define REG_SLPCON1 0x220 #define REG_WAKETIMEL 0x222 /* Wake-up Time Match Value Low */ #define REG_WAKETIMEH 0x223 /* Wake-up Time Match Value High */ +#define REG_REMCNTL 0x224 +#define REG_REMCNTH 0x225 +#define REG_MAINCNT0 0x226 +#define REG_MAINCNT1 0x227 +#define REG_MAINCNT2 0x228 +#define REG_MAINCNT3 0x229 #define REG_TESTMODE 0x22F /* Test mode */ +#define REG_ASSOEAR0 0x230 +#define REG_ASSOEAR1 0x231 +#define REG_ASSOEAR2 0x232 +#define REG_ASSOEAR3 0x233 +#define REG_ASSOEAR4 0x234 +#define REG_ASSOEAR5 0x235 +#define REG_ASSOEAR6 0x236 +#define REG_ASSOEAR7 0x237 +#define REG_ASSOSAR0 0x238 +#define REG_ASSOSAR1 0x239 +#define REG_UNONCE0 0x240 +#define REG_UNONCE1 0x241 +#define REG_UNONCE2 0x242 +#define REG_UNONCE3 0x243 +#define REG_UNONCE4 0x244 +#define REG_UNONCE5 0x245 +#define REG_UNONCE6 0x246 +#define REG_UNONCE7 0x247 +#define REG_UNONCE8 0x248 +#define REG_UNONCE9 0x249 +#define REG_UNONCE10 0x24A +#define REG_UNONCE11 0x24B +#define REG_UNONCE12 0x24C #define REG_RX_FIFO 0x300 /* Receive FIFO */ /* Device configuration: Only channels 11-26 on page 0 are supported. */ -- 2.5.2 -- To unsubscribe from this list: send the line "unsubscribe linux-wpan" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
