Hello.
Nothing to be appliad to the kernel but rather the atusb firmware repo. Just
sending it here as it is releated to the mainline driver and the device users
are reading here.
These are the four patches I consider we need to have a working 0.2 release.
The revert might be only needed for my qemu setup with USB passthrough, but
without it I'm not able to get the device to show up in qemu. Thoughts
appreciated.
Using RX_AACK_ON sounds like a good idea as we loose nothing but work also work
well with nodes using ARET.
Bumping to version 0.2 and adding the need magic to add a valid DFU suffix to
the firmware file. I will followup with a mail attaching the binary I'm using
right now and I consider the final 0.2 if everyone agrees with these patches.
Stefan Schmidt (4):
Revert "atusb/fw/usb/: enable MCU reset on USB bus reset after config
selection"
atusb/fw: Use RX_AACK_ON instead of RX_ON in the firmware.
atusb/fw: Add build system support for adding a DFU suffix to the fw
file
atusb/fw: Bump minor version to mark first public release.
atusb/fw/Makefile | 17 +++++++++++++----
atusb/fw/include/atusb/ep0.h | 3 ++-
atusb/fw/mac.c | 6 +++---
atusb/fw/usb/atu2.c | 7 +------
atusb/fw/usb/usb.c | 1 -
atusb/fw/usb/usb.h | 1 -
6 files changed, 19 insertions(+), 16 deletions(-)
regards
Stefan Schmidt
--
2.1.0
--
To unsubscribe from this list: send the line "unsubscribe linux-wpan" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
