This new callback can be used to tune the rate to be used to send
multicast frames.
In the current state the multicast rate can be specified on IBSS/MESH
joining only. This makes it impossible to select a custom multicast
rate when then join command is sent by an external program (e.g.
wpa_supplicant)
Signed-off-by: Antonio Quartulli <ordex@xxxxxxxxxxxxx>
---
net/mac80211/cfg.c | 11 +++++++++++
1 file changed, 11 insertions(+)
diff --git a/net/mac80211/cfg.c b/net/mac80211/cfg.c
index eebb70b..80e0618 100644
--- a/net/mac80211/cfg.c
+++ b/net/mac80211/cfg.c
@@ -1954,6 +1954,16 @@ static int ieee80211_leave_ibss(struct wiphy *wiphy, struct net_device *dev)
return ieee80211_ibss_leave(IEEE80211_DEV_TO_SUB_IF(dev));
}
+static int ieee80211_set_mcast_rate(struct wiphy *wiphy, struct net_device *dev,
+ int rate[IEEE80211_NUM_BANDS])
+{
+ struct ieee80211_sub_if_data *sdata = IEEE80211_DEV_TO_SUB_IF(dev);
+
+ memcpy(sdata->vif.bss_conf.mcast_rate, rate, sizeof(rate));
+
+ return 0;
+}
+
static int ieee80211_set_wiphy_params(struct wiphy *wiphy, u32 changed)
{
struct ieee80211_local *local = wiphy_priv(wiphy);
@@ -3180,6 +3190,7 @@ struct cfg80211_ops mac80211_config_ops = {
.disassoc = ieee80211_disassoc,
.join_ibss = ieee80211_join_ibss,
.leave_ibss = ieee80211_leave_ibss,
+ .set_mcast_rate = ieee80211_set_mcast_rate,
.set_wiphy_params = ieee80211_set_wiphy_params,
.set_tx_power = ieee80211_set_tx_power,
.get_tx_power = ieee80211_get_tx_power,
--
1.7.12.4
--
To unsubscribe from this list: send the line "unsubscribe linux-wireless" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
