Search Linux Wireless

Re: [PATCH 00/31] wlcore/wl18xx/wl12xx patches for 3.7

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Thu, 2012-09-27 at 13:37 +0300, Luciano Coelho wrote:
> Hi,
> 
> This is a bunch of patches that have accumulated in our internal tree
> and are intended for 3.7.  Mostly bug-fixes and small improvements all
> over.
> 
> Cheers,
> Luca.
> 
> Arik Nemtsov (9):
>   wlcore: AP mode - send non-data packets with basic rates
>   wlcore: allow only the lowest OFDM rate for p2p setup frames
>   wlcore: make Tx flush timings more verbose
>   wlcore: tx_flush - optimize flow and force Tx during the flush
>   wlcore/wl18xx/wl12xx: allow up to 3 mac addresses
>   wlcore: make debug prints work without dynamic debug
>   wlcore: allow up to 3 running STA interfaces in combinations
>   wlcore: spi: use private max-buf-size limit
>   wl18xx: default to siso40 in 2.4ghz with a single antenna
> 
> Eliad Peller (9):
>   wlcore: consider single fw case
>   wlcore: cancel recovery_work on stop() instead of remove_interface()
>   wlcore: resume() only if sta is associated
>   wlcore: always use wlvif->role_id for scans
>   wlcore: lazy-enable device roles
>   wlcore: invalidate keep-alive template on disconnection
>   wlcore: use dynamic keep-alive template ids
>   wlcore: decrease elp timeout
>   wlcore: protect wlcore_op_set_key with mutex
> 
> Eyal Shapira (1):
>   wlcore: configure wowlan regardless of wakeup conditions
> 
> Ido Reis (2):
>   wl18xx: update default phy configuration for pg2
>   wl18xx: increase rx_ba_win_size to 32
> 
> Ido Yariv (6):
>   wlcore: Prevent interaction with HW after recovery is queued
>   wlcore: Don't recover during boot
>   wlcore: Fix unbalanced interrupts enablement
>   wlcore: Allow memory access when the FW crashes
>   wlcore: Refactor probe
>   wlcore: Load the NVS file asynchronously
> 
> Igal Chernobelsky (2):
>   wl18xx/wl12xx: defines for Tx/Rx descriptors num
>   wlcore/wl18xx/wl12xx: aggregation buffer size set
> 
> Yair Shapira (2):
>   wl18xx: number_of_assembled_ant5 indicates if A band is enabled
>   wlcore/wl18xx: add phy_fw_version_str to debugfs driver_state

Applied the series.  Thanks to all the contributers!

--
Luca.

--
To unsubscribe from this list: send the line "unsubscribe linux-wireless" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html


[Index of Archives]     [Linux Host AP]     [ATH6KL]     [Linux Wireless Personal Area Network]     [Linux Bluetooth]     [Linux Netdev]     [Kernel Newbies]     [Linux Kernel]     [IDE]     [Git]     [Netfilter]     [Bugtraq]     [Yosemite Hiking]     [MIPS Linux]     [ARM Linux]     [Linux RAID]

  Powered by Linux