Search Linux Wireless

Re: ath9k: AR9462 btcoex doesn't appear to work

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Sun, Aug 26, 2012 at 01:18:10AM -0400, Sherwin Soltani wrote:
> On 08/25/2012 09:58 PM, Sujith Manoharan wrote:
> >Sherwin Soltani wrote:
> >>I have an Acer Aspire V5-571 which contains the AR9462 chipset (PCI ID
> >>168c:0034), supported by the ath9k driver. This chipset claims to
> >>support Bluetooth coexistence. However, after booting up, my kernel does
> >>not register any Bluetooth devices.
> >>
> >>I am using kernel version 3.6.0-999-generic (apw@gomeisa) (gcc version
> >>4.6.3 (Ubuntu/Linaro 4.6.3-1ubuntu5)). I also tried 3.4 and 3.2 kernels
> >>without success. Additionally, I can try to do
> >>
> >>rmmod ath9k && modprobe ath9k btcoex_enable=1
> >>
> >>In the message log, I can see this:
> >>
> >>[ 1204.643120] ath9k: ath9k: Driver unloaded
> >>[ 1214.203099] ath: phy1: Disabling ASPM since BTCOEX is enabled
> >>[ 1214.203105] ath: EEPROM regdomain: 0x6a
> >>[ 1214.203106] ath: EEPROM indicates we should expect a direct regpair map
> >>[ 1214.203108] ath: Country alpha2 being used: 00
> >>[ 1214.203109] ath: Regpair used: 0x6a
> >>
> >>However 'hcitool dev' shows no devices after this operation.
> >What does lsusb -v show ?
>
I hope it is lspci's output not lsusb?
> It shows:
> 
> 03:00.0 Network controller: Atheros Communications Inc. AR9462
> Wireless Network Adapter (rev 01)
>     Subsystem: Lite-On Communications Inc Device 6621
>     Flags: bus master, fast devsel, latency 0, IRQ 19
>     Memory at f0500000 (64-bit, non-prefetchable) [size=512K]
>     Expansion ROM at dfa00000 [disabled] [size=64K]
>     Capabilities: [40] Power Management version 2
>     Capabilities: [50] MSI: Enable- Count=1/4 Maskable+ 64bit+
>     Capabilities: [70] Express Endpoint, MSI 00
>     Capabilities: [100] Advanced Error Reporting
>     Capabilities: [140] Virtual Channel
>     Capabilities: [160] Device Serial Number 00-00-00-00-00-00-00-00
>     Kernel driver in use: ath9k
>     Kernel modules: ath9k
> 
> >...
> >
> >Reload ath3k and something like this should be seen:
> >
> >root@linux-test ~# hciconfig hci1 up
> >root@linux-test ~# hcitool dev
> >Devices:
> >         hci1    00:03:7F:44:84:8A
> 
> By ath3k, I assume you meant ath9k since that is the driver I was
> using. After loading up the new firmware, I still have no devices
> shown (and 'hciconfig hci1 up' replies with 'No such device').
> Rebooting doesn't help.
> 
No. ath3k is BT firmware downloader that loads BT firmware into the target.
Can you please confirm whether you have ath3k driver or not? BT device will be
enumerated as usb device. Can you you share lsusb list and complete kernel log?

--
Rajkumar
> Here is what I see in the message buffer after re-inserting ath9k:
> [19157.961388] ath9k: ath9k: Driver unloaded
> [19178.196366] ath: phy2: ASPM enabled: 0x43
> [19178.196371] ath: EEPROM regdomain: 0x6a
> [19178.196372] ath: EEPROM indicates we should expect a direct regpair map
> [19178.196375] ath: Country alpha2 being used: 00
> [19178.196376] ath: Regpair used: 0x6a
> 
> ... lots of cfg80211 info ...
> 
> [19178.197491] Registered led device: ath9k-phy2
> [19178.197500] ieee80211 phy2: Atheros AR9462 Rev:2
> mem=0xffffc90016300000, irq=19
> [19178.211376] IPv6: ADDRCONF(NETDEV_UP): wlan0: link is not ready
> [19186.703984] wlan0: authenticate with 2c:b0:5d:45:33:58
> [19186.708760] wlan0: send auth to 2c:b0:5d:45:33:58 (try 1/3)
> [19186.759145] wlan0: authenticated
> [19186.765888] wlan0: associate with 2c:b0:5d:45:33:58 (try 1/3)
> [19186.863455] wlan0: RX AssocResp from 2c:b0:5d:45:33:58
> (capab=0x411 status=0 aid=2)
> [19186.863561] wlan0: associated
> 
> >Coexistence testing is ongoing and bugs are still being ironed out,
> >but basic support is mostly done.
> >
> >>Aside from the Bluetooth problems, there are also problems with
> >>frequently dropping signals (even when I am very close to the access
> >>point), but right now that's a secondary concern to Bluetooth for me.
> >Can you try with the latest driver (using compat-wireless) and see if the
> >problem persists ? If it does, please post the kernel log with driver
> >debugging set to 0x8f49.
> 
> I will take a look at what happens with compat-wireless.
> 
> --
> To unsubscribe from this list: send the line "unsubscribe linux-wireless" in
> the body of a message to majordomo@xxxxxxxxxxxxxxx
> More majordomo info at  http://vger.kernel.org/majordomo-info.html
--
To unsubscribe from this list: send the line "unsubscribe linux-wireless" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html


[Index of Archives]     [Linux Host AP]     [ATH6KL]     [Linux Wireless Personal Area Network]     [Linux Bluetooth]     [Linux Netdev]     [Kernel Newbies]     [Linux Kernel]     [IDE]     [Git]     [Netfilter]     [Bugtraq]     [Yosemite Hiking]     [MIPS Linux]     [ARM Linux]     [Linux RAID]

  Powered by Linux