On 2012-08-08 4:55 PM, Rajkumar Manoharan wrote: > On Tue, Aug 07, 2012 at 03:06:12PM +0200, Felix Fietkau wrote: >> This feature had been disabled in ath9k because the code to support >> it was incomplete, but now the code is in sync with the internal QCA >> codebase, so it's time to enable it. >> >> On many newer devices, the calibration is assumed to be done with PA >> linearization enabled. >> >> Tests with a particular AR933x device showed that the signal emitted >> at full power was highly distorted and unreliable with PA linearization >> disabled. With this patch, the signal becomes clear and stability >> is improved. >> > We faced stability issues with 938x chipsets when paprd is enabled. The commit > 6f4810101a629b31b5427872a09ea092cfc5c4bd states one of the issue. Even if it > helps for AR933x, let us enable it only for that chip alone. That was in January 2011, lots of bugs have been fixed since then, initvals have been updated, EEPROM code has changed, ... The internal QCA codebase enables PAPRD for all AR93xx devices that support it, meaning non-PAPRD tx receives much less test coverage there. While this issue has only been visible on a particular AR933x device, I believe this is not the only one that's going to be affected, as the EEPROM of any new device is calibrated for PAPRD-enabled operation. If you don't want to enable it now, when do you think would be the right time to enable it? Before I sent this patch, I did a detailed code review to make sure that any obvious code discrepancies in PAPRD between the internal codebase and ath9k are dealt with. What else is needed to get this issue sorted out? - Felix -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
