Make sure we don't store the table offsets for min and cur power levels, store the 0.25dB values instead. This way we don't clamp the tx power level to max (because now cur_pwr holds the 0.25dB value, not the table offset) after re-using cur_pwr on reset. Signed-off-by: Nick Kossifidis <mickflemm@xxxxxxxxx> --- drivers/net/wireless/ath/ath5k/phy.c | 19 ++++++++++++++----- 1 files changed, 14 insertions(+), 5 deletions(-) diff --git a/drivers/net/wireless/ath/ath5k/phy.c b/drivers/net/wireless/ath/ath5k/phy.c index 8b71a2d..aa1a77d 100644 --- a/drivers/net/wireless/ath/ath5k/phy.c +++ b/drivers/net/wireless/ath/ath5k/phy.c @@ -3562,6 +3562,20 @@ ath5k_setup_rate_powertable(struct ath5k_hw *ah, u16 max_pwr, for (i = 8; i <= 15; i++) rates[i] -= ah->ah_txpower.txp_cck_ofdm_gainf_delta; + /* Save min/max and current tx power for this channel + * in 0.25dB units. + * + * Note: We use rates[0] for current tx power because + * it covers most of the rates, in most cases. It's our + * tx power limit and what the user expects to see. */ + ah->ah_txpower.txp_min_pwr = 2 * rates[7]; + ah->ah_txpower.txp_cur_pwr = 2 * rates[0]; + + /* Set max txpower for correct OFDM operation on all rates + * -that is the txpower for 54Mbit-, it's used for the PAPD + * gain probe and it's in 0.5dB units */ + ah->ah_txpower.txp_ofdm = rates[7]; + /* Now that we have all rates setup use table offset to * match the power range set by user with the power indices * on PCDAC/PDADC table */ @@ -3571,11 +3585,6 @@ ath5k_setup_rate_powertable(struct ath5k_hw *ah, u16 max_pwr, if (rates[i] > 63) rates[i] = 63; } - - /* Min/max in 0.25dB units */ - ah->ah_txpower.txp_min_pwr = 2 * rates[7]; - ah->ah_txpower.txp_cur_pwr = 2 * rates[0]; - ah->ah_txpower.txp_ofdm = rates[7]; } -- 1.7.3.4 -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
