* Do not set/clear TSF when adding/deleting an interface. This should be done when the BSS is set up and should also take into account the existence of other interfaces. * Set opmode explicitly. * ANI setup needs to be decided based on multiple interfaces. This can be done via the bss_info_changed() callback. Signed-off-by: Sujith Manoharan <c_manoha@xxxxxxxxxxxxxxxx> --- drivers/net/wireless/ath/ath9k/main.c | 17 ++--------------- 1 file changed, 2 insertions(+), 15 deletions(-) diff --git a/drivers/net/wireless/ath/ath9k/main.c b/drivers/net/wireless/ath/ath9k/main.c index 1265add..2619bd3 100644 --- a/drivers/net/wireless/ath/ath9k/main.c +++ b/drivers/net/wireless/ath/ath9k/main.c @@ -913,11 +913,9 @@ static void ath9k_calculate_summary_state(struct ieee80211_hw *hw, if (iter_data.naps > 0) { ath9k_hw_set_tsfadjust(ah, true); - set_bit(SC_OP_TSF_RESET, &sc->sc_flags); ah->opmode = NL80211_IFTYPE_AP; } else { ath9k_hw_set_tsfadjust(ah, false); - clear_bit(SC_OP_TSF_RESET, &sc->sc_flags); if (iter_data.nmeshes) ah->opmode = NL80211_IFTYPE_MESH_POINT; @@ -929,25 +927,14 @@ static void ath9k_calculate_summary_state(struct ieee80211_hw *hw, ah->opmode = NL80211_IFTYPE_STATION; } + ath9k_hw_setopmode(ah); + if ((iter_data.nstations + iter_data.nadhocs + iter_data.nmeshes) > 0) ah->imask |= ATH9K_INT_TSFOOR; else ah->imask &= ~ATH9K_INT_TSFOOR; ath9k_hw_set_interrupts(ah); - - if (iter_data.naps > 0) { - sc->sc_ah->stats.avgbrssi = ATH_RSSI_DUMMY_MARKER; - - if (!common->disable_ani) { - set_bit(SC_OP_ANI_RUN, &sc->sc_flags); - ath_start_ani(common); - } - - } else { - clear_bit(SC_OP_ANI_RUN, &sc->sc_flags); - del_timer_sync(&common->ani.timer); - } } static int ath9k_add_interface(struct ieee80211_hw *hw, -- 1.7.11.1 -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html