Thomas,
Yes, I did like that.
iw phy phy0 interface add mesh0 type mp mesh_id mymesh
iw dev mesh0 set channel 48 HT20
ifconfig mesh0 up
However, if I use iw to set bitrate, something like that "iw mesh0 set
bitrates legacy-5 54 mcs-5 15". Then use "iw dev mesh0 station dump" to
check bitrate. It seems like only show 54Mbps or below bitrates. HT mcs
rate can not be controlled?
Any help appreciate.
Thanks,
Bin
On 05/10/2012 06:20 PM, Thomas Pedersen wrote:
Hey Bin,
On Thu, May 10, 2012 at 1:56 PM, Bin Zeng<bzeng@xxxxxxxxxxxxxxxxx> wrote:
Hi
I created a MESH network by using 802.11n supported cards, however, MESH
only works at 54Mbps link rate or below.
Can anyone tell me how to active the 802.11n ht mode in mesh?
Just set the channel type to HT, something like:
iw wlan0 set channel 1 HT20
Before joining the mesh.
Thomas
--
To unsubscribe from this list: send the line "unsubscribe linux-wireless" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html