Hello Janusz, > Seems this flag is per vif in new compat now. > IEEE80211_VIF_BEACON_FILTER > IEEE80211_VIF_SUPPORTS_CQM_RSSI > > So, you should configure this in cw1200_add_interface() for new > compat-wireless: > > vif->driver_flags |= IEEE80211_VIF_BEACON_FILTER | > IEEE80211_VIF_SUPPORTS_CQM_RSSI; Thanks for the suggestion. I will take a look at this tomorrow. On a positive note, just before leaving for the day I fired up hostapd and was able to connect a couple clients to the cw1200 in AP mode! I didn't test it very much but it seemed to be working okay. I transferred a couple hundred MB of data without any issue. I was only getting about 500kB per second but I suspect all the logging I have turned on may be slowing it down. I am not even sure what rate I was connected at as I was using an old MacBook for the test and not being a Mac guy I couldn't figure out how to see what rate the WiFi was connected at. So if AP mode is working station mode can't be that far off... Thanks, Kevin -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
