From: Andrei Emeltchenko <andrei.emeltchenko@xxxxxxxxx> RFC for Software / Virtual _DRAFT_ implementation of Bluetooth High Speed by using wireless driver. Currently it can be used for testing Bluetooth A2MP protocol. Changes: RFCv2: Process basic HCI commands and basic data traffic; added skeleton for Netlink comms, took comments from reviewers. RFCv1: Initial release. TODO: Change names from vamp to <softamp|bt_softamp|etc> Main ideas: - Use existing wireless infrastructure nl80211, mac80211. - Use virtual interface of type NL80211_IFTYPE_BLUETOOTH_AMP. Then all drivers supporting virtual interface should work. After modifying iw it will be enabled by adding new virtual interface. # iw phy <physical device> interface add vamp type vamp # iw dev phy#0 Interface vamp ifindex 6 type Virtual AMP ... # hciconfig hci1: Type: AMP Bus: VIRTUAL BD Address: 00:00:00:00:00:00 ACL MTU: 0:0 SCO MTU: 0:0 DOWN RX bytes:0 acl:0 sco:0 events:0 errors:0 TX bytes:0 acl:0 sco:0 commands:0 errors:0 ... Andrei Emeltchenko (6): mac80211: softamp: Adds Bluetooth Software AMP mac80211: softamp: Adds build config option hwsim: Adds support for BT SOFTAMP for testing mac80211: softamp: Handle assoc request mac80211: softamp: Netlink interface to softamp mac80211: softamp: Handle data traffic drivers/net/wireless/mac80211_hwsim.c | 3 +- include/linux/ieee80211.h | 13 + include/linux/nl80211.h | 1 + net/mac80211/Kconfig | 9 + net/mac80211/Makefile | 2 + net/mac80211/ieee80211_i.h | 5 + net/mac80211/iface.c | 9 + net/mac80211/rx.c | 4 + net/mac80211/sta_info.h | 4 + net/mac80211/util.c | 1 + net/mac80211/virtual_amp.c | 675 +++++++++++++++++++++++++++++++++ net/mac80211/virtual_amp.h | 96 +++++ 12 files changed, 821 insertions(+), 1 deletion(-) create mode 100644 net/mac80211/virtual_amp.c create mode 100644 net/mac80211/virtual_amp.h -- 1.7.9.5 -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html