Hi Andrei, > > > > > > This is also a little bit of confusing since FullMac cards will not > > > > > > create an AMP virtual interface. With them you just see the HCI AMP > > > > > > controller on the Bluetooth side. Can an AMP virtual interface be just > > > > > > virtual inside mac80211 or does it have to have a netdev attached to it? > > > > > > > > > > If we create virtual interface then netdev is allocated and we can handle > > > > > it with common tools. > > > > > > > > what common tools do you wanna use here. We actually do not wanna have > > > > them show up as netdev devices at all. AMP connections don't have IP > > > > addresses or anything else for that matter. > > > > > > I might want to set up MAC address. Otherwise I might not need netdev. I > > > feel that I need it for interface separation. > > > > what MAC address? And where do you get this MAC address from? AMP > > controllers do not have MAC addresses. > > I assume I need some address to send/receive data over wireless. from a Bluetooth point, we do not have to deal with the MAC address. When looking at the mac80211 part, I do not know. However even then, that address should come from the driver and not from userspace. Regards Marcel -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
