Add ATH6KL_CONF_UART_DEBUG which is set whenever uart_debug module
parameter is enabled. This way we can keep the uart_debug parameter
static when core.c file is introduced.
Signed-off-by: Kalle Valo <kvalo@xxxxxxxxxxxxxxxx>
---
drivers/net/wireless/ath/ath6kl/core.h | 1 +
drivers/net/wireless/ath/ath6kl/init.c | 5 ++++-
2 files changed, 5 insertions(+), 1 deletions(-)
diff --git a/drivers/net/wireless/ath/ath6kl/core.h b/drivers/net/wireless/ath/ath6kl/core.h
index a75c09e..5b48ed4 100644
--- a/drivers/net/wireless/ath/ath6kl/core.h
+++ b/drivers/net/wireless/ath/ath6kl/core.h
@@ -195,6 +195,7 @@ struct ath6kl_fw_ie {
#define ATH6KL_CONF_ENABLE_11N BIT(2)
#define ATH6KL_CONF_ENABLE_TX_BURST BIT(3)
#define ATH6KL_CONF_SUSPEND_CUTPOWER BIT(4)
+#define ATH6KL_CONF_UART_DEBUG BIT(5)
enum wlan_low_pwr_state {
WLAN_POWER_STATE_ON,
diff --git a/drivers/net/wireless/ath/ath6kl/init.c b/drivers/net/wireless/ath/ath6kl/init.c
index 6baa855..911e2df 100644
--- a/drivers/net/wireless/ath/ath6kl/init.c
+++ b/drivers/net/wireless/ath/ath6kl/init.c
@@ -466,7 +466,7 @@ int ath6kl_configure_target(struct ath6kl *ar)
u8 fw_iftype, fw_mode = 0, fw_submode = 0;
int i, status;
- param = uart_debug;
+ param = !!(ar->conf_flags & ATH6KL_CONF_UART_DEBUG);
if (ath6kl_bmi_write(ar, ath6kl_get_hi_item_addr(ar,
HI_ITEM(hi_serial_enable)), (u8 *)¶m, 4)) {
ath6kl_err("bmi_write_memory for uart debug failed\n");
@@ -1679,6 +1679,9 @@ int ath6kl_core_init(struct ath6kl *ar)
if (suspend_cutpower)
ar->conf_flags |= ATH6KL_CONF_SUSPEND_CUTPOWER;
+ if (uart_debug)
+ ar->conf_flags |= ATH6KL_CONF_UART_DEBUG;
+
ar->wiphy->flags |= WIPHY_FLAG_SUPPORTS_FW_ROAM |
WIPHY_FLAG_HAVE_AP_SME |
WIPHY_FLAG_HAS_REMAIN_ON_CHANNEL |
--
To unsubscribe from this list: send the line "unsubscribe linux-wireless" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
