Dear Simon
I have read your patches on adding supports for MCS rates, both iw and compat-
wireless, it seems interesting.
For evaluation purpose, I have added the patches to Compat-wireless and IW. It
seems compiling and running fine.
But when I tried to set up the rate, through iw set bitrates command, it does
not work. Please refer to the following dumping message for further details:
----------------------------------------------
root@Openwrt:/sys/kernel/debug/ieee80211/phy0# iw dev wlan0.sta1 set bitrates
mcs-5 14
root@Openwrt:/sys/kernel/debug/ieee80211/phy0# iw dev wlan0.sta1 station dump
Station 00:xx::xx:xx:xx (on wlan0.sta1)
inactive time: 490 ms
rx bytes: 1739675
rx packets: 15179
tx bytes: 7421803
tx packets: 14051
tx retries: 714
tx failed: 139
signal: -45 dBm
signal_ctl0: -46 dBm
signal_ctl1: -45 dBm
tx bitrate: 6.0 MBit/s
rx bitrate: 6.0 MBit/s
root@Javelin:/sys/kernel/debug/ieee80211/phy0#
--------------------------------------------------------------------------------
-------
I have tested both with ack and noack, but it still does not work
Both AP and STA are in WDS.
Can you check for me whether the set command is correct and whether it can work
in AP/STA mode ?
Once again, Thanks you very much for your kind helps and considerations and I
look forward to receiving information from you.
Yours sincerely
Le
--
To unsubscribe from this list: send the line "unsubscribe linux-wireless" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
