P2P still under development. it will not enabled by default, but user always can enable it manually for testing. Signed-off-by: Wey-Yi Guy <wey-yi.w.guy@xxxxxxxxx> --- drivers/net/wireless/iwlwifi/Kconfig | 16 ++++++++++++++++ drivers/net/wireless/iwlwifi/iwl-agn.c | 10 +++++++++- 2 files changed, 25 insertions(+), 1 deletions(-) diff --git a/drivers/net/wireless/iwlwifi/Kconfig b/drivers/net/wireless/iwlwifi/Kconfig index 82c8cca..ae08498 100644 --- a/drivers/net/wireless/iwlwifi/Kconfig +++ b/drivers/net/wireless/iwlwifi/Kconfig @@ -111,3 +111,19 @@ config IWLWIFI_DEVICE_TESTMODE NL80211_TESTMODE. This provide the capabilities of enable user space validation applications to interacts with the device through the generic netlink message via NL80211_TESTMODE channel. + +config IWLWIFI_P2P + bool "iwlwifi experimental P2P support" + depends on IWLWIFI + help + This option enables experimental P2P support for some devices + based on microcode support. Since P2P support is still under + development, this option may even enable it for some devices + now that turn out to not support it in the future due to + microcode restrictions. + + To determine if your microcode supports the experimental P2P + offered by this option, check if the driver advertises AP + support when it is loaded. + + Say Y only if you want to experiment with P2P. diff --git a/drivers/net/wireless/iwlwifi/iwl-agn.c b/drivers/net/wireless/iwlwifi/iwl-agn.c index 5021cc9..6dd1e10 100644 --- a/drivers/net/wireless/iwlwifi/iwl-agn.c +++ b/drivers/net/wireless/iwlwifi/iwl-agn.c @@ -1036,6 +1036,9 @@ static void iwl_ucode_callback(const struct firmware *ucode_raw, void *context) priv->inst_evtlog_size = priv->cfg->base_params->max_event_log_size; priv->inst_errlog_ptr = pieces.inst_errlog_ptr; +#ifndef CONFIG_IWLWIFI_P2P + ucode_capa.flags &= ~IWL_UCODE_TLV_FLAGS_PAN; +#endif priv->new_scan_threshold_behaviour = !!(ucode_capa.flags & IWL_UCODE_TLV_FLAGS_NEWSCAN); @@ -1057,7 +1060,6 @@ static void iwl_ucode_callback(const struct firmware *ucode_raw, void *context) priv->sta_key_max_num = STA_KEY_MAX_NUM; priv->shrd->cmd_queue = IWL_DEFAULT_CMD_QUEUE_NUM; } - /* * figure out the offset of chain noise reset and gain commands * base on the size of standard phy calibration commands table size @@ -1709,6 +1711,12 @@ static void iwl_debug_config(struct iwl_priv *priv) #else "disabled\n"); #endif + dev_printk(KERN_INFO, bus(priv)->dev, "CONFIG_IWLWIFI_P2P " +#ifdef CONFIG_IWLWIFI_P2P + "enabled\n"); +#else + "disabled\n"); +#endif } int iwl_probe(struct iwl_bus *bus, const struct iwl_trans_ops *trans_ops, -- 1.7.0.4 -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
