On 2011-09-29 1:24 PM, Rajkumar Manoharan wrote:
Select appropriate rate as highest rate of rate series, if the frame
was asked to be sent at minimum rate. For example nullfunc frames
either can be sent at HT rates on normal case or at non-HT rates if
it is used for connection monitoring.
Signed-off-by: Rajkumar Manoharan<rmanohar@xxxxxxxxxxxxxxxx>
---
drivers/net/wireless/ath/ath9k/rc.c | 4 ++--
1 files changed, 2 insertions(+), 2 deletions(-)
Shouldn't the check for IEEE80211_TX_CTL_USE_MINRATE be in
rate_control_send_low(), so that it does not have to be repeated in
every single rate control module?
- Felix
--
To unsubscribe from this list: send the line "unsubscribe linux-wireless" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
