This adds support for serial console to bcma, when operating on an SoC.
Signed-off-by: Hauke Mehrtens <hauke@xxxxxxxxxx>
---
drivers/bcma/bcma_private.h | 6 +++
drivers/bcma/driver_chipcommon.c | 64 +++++++++++++++++++++++++++++++++
drivers/bcma/driver_mips.c | 9 +++++
include/linux/bcma/bcma_driver_mips.h | 11 ++++++
4 files changed, 90 insertions(+), 0 deletions(-)
diff --git a/drivers/bcma/bcma_private.h b/drivers/bcma/bcma_private.h
index 830386c..92ec671 100644
--- a/drivers/bcma/bcma_private.h
+++ b/drivers/bcma/bcma_private.h
@@ -26,6 +26,12 @@ int __init bcma_bus_scan_early(struct bcma_bus *bus,
struct bcma_device *core);
void bcma_init_bus(struct bcma_bus *bus);
+/* driver_chipcommon.c */
+#ifdef CONFIG_BCMA_DRIVER_MIPS
+extern int bcma_chipco_serial_init(struct bcma_drv_cc *cc,
+ struct bcma_drv_mips_serial_port *ports);
+#endif /* CONFIG_BCMA_DRIVER_MIPS */
+
#ifdef CONFIG_BCMA_HOST_PCI
/* host_pci.c */
extern int __init bcma_host_pci_init(void);
diff --git a/drivers/bcma/driver_chipcommon.c b/drivers/bcma/driver_chipcommon.c
index 70321c6..88533ca 100644
--- a/drivers/bcma/driver_chipcommon.c
+++ b/drivers/bcma/driver_chipcommon.c
@@ -92,3 +92,67 @@ u32 bcma_chipco_gpio_polarity(struct bcma_drv_cc *cc, u32 mask, u32 value)
{
return bcma_cc_write32_masked(cc, BCMA_CC_GPIOPOL, mask, value);
}
+
+#ifdef CONFIG_BCMA_DRIVER_MIPS
+int bcma_chipco_serial_init(struct bcma_drv_cc *cc,
+ struct bcma_drv_mips_serial_port *ports)
+{
+ int nr_ports = 0;
+ u32 plltype;
+ unsigned int irq;
+ u32 baud_base, div;
+ u32 i, n;
+ unsigned int ccrev = cc->core->id.rev;
+
+ plltype = (cc->capabilities & BCMA_CC_CAP_PLLT);
+ irq = bcma_core_mips_irq(cc->core);
+
+ if ((ccrev >= 11) && (ccrev != 15) && (ccrev != 20)) {
+ /* Fixed ALP clock */
+ baud_base = 20000000;
+ if (cc->capabilities & BCMA_CC_CAP_PMU) {
+ /* FIXME: baud_base is different for devices with a PMU */
+ WARN_ON(1);
+ }
+ div = 1;
+ if (ccrev >= 21) {
+ /* Turn off UART clock before switching clocksource. */
+ bcma_cc_write32(cc, BCMA_CC_CORECTL,
+ bcma_cc_read32(cc, BCMA_CC_CORECTL)
+ & ~BCMA_CC_CORECTL_UARTCLKEN);
+ }
+ /* Set the override bit so we don't divide it */
+ bcma_cc_write32(cc, BCMA_CC_CORECTL,
+ bcma_cc_read32(cc, BCMA_CC_CORECTL)
+ | BCMA_CC_CORECTL_UARTCLK0);
+ if (ccrev >= 21) {
+ /* Re-enable the UART clock. */
+ bcma_cc_write32(cc, BCMA_CC_CORECTL,
+ bcma_cc_read32(cc, BCMA_CC_CORECTL)
+ | BCMA_CC_CORECTL_UARTCLKEN);
+ }
+ } else
+ pr_err("serial not supported on this device ccrev: 0x%x\n",
+ ccrev);
+
+ /* Determine the registers of the UARTs */
+ n = (cc->capabilities & BCMA_CC_CAP_NRUART);
+ for (i = 0; i < n; i++) {
+ void __iomem *cc_mmio;
+ void __iomem *uart_regs;
+
+ cc_mmio = cc->core->bus->mmio +
+ (cc->core->core_index * BCMA_CORE_SIZE);
+ uart_regs = cc_mmio + BCMA_CC_UART0_DATA;
+ uart_regs += (i * 256);
+
+ nr_ports++;
+ ports[i].regs = uart_regs;
+ ports[i].irq = irq;
+ ports[i].baud_base = baud_base;
+ ports[i].reg_shift = 0;
+ }
+
+ return nr_ports;
+}
+#endif /* CONFIG_BCMA_DRIVER_MIPS */
diff --git a/drivers/bcma/driver_mips.c b/drivers/bcma/driver_mips.c
index 605bb08..3989fb9 100644
--- a/drivers/bcma/driver_mips.c
+++ b/drivers/bcma/driver_mips.c
@@ -156,6 +156,14 @@ static void bcma_core_mips_dump_irq(struct bcma_bus *bus)
}
}
+static void bcma_core_mips_serial_init(struct bcma_drv_mips *mcore)
+{
+ struct bcma_bus *bus = mcore->core->bus;
+
+ mcore->nr_serial_ports = bcma_chipco_serial_init(&bus->drv_cc,
+ mcore->serial_ports);
+}
+
static void bcma_core_mips_flash_detect(struct bcma_drv_mips *mcore)
{
struct bcma_bus *bus = mcore->core->bus;
@@ -228,6 +236,7 @@ void bcma_core_mips_init(struct bcma_drv_mips *mcore)
if (mcore->setup_done)
return;
+ bcma_core_mips_serial_init(mcore);
bcma_core_mips_flash_detect(mcore);
mcore->setup_done = true;
}
diff --git a/include/linux/bcma/bcma_driver_mips.h b/include/linux/bcma/bcma_driver_mips.h
index f19b21a..13b44c2 100644
--- a/include/linux/bcma/bcma_driver_mips.h
+++ b/include/linux/bcma/bcma_driver_mips.h
@@ -32,11 +32,22 @@
struct bcma_device;
+struct bcma_drv_mips_serial_port {
+ void *regs;
+ unsigned long clockspeed;
+ unsigned int irq;
+ unsigned int baud_base;
+ unsigned int reg_shift;
+};
+
struct bcma_drv_mips {
struct bcma_device *core;
u8 setup_done:1;
unsigned int assigned_irqs;
+ int nr_serial_ports;
+ struct bcma_drv_mips_serial_port serial_ports[4];
+
u8 flash_buswidth;
u32 flash_window;
u32 flash_window_size;
--
1.7.4.1
--
To unsubscribe from this list: send the line "unsubscribe linux-wireless" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
